"THE SEALED ROOM" 3lbs A LIGHT

[Tranoble]

The highest my Co2 evar gets is 2200 ppm and thats only if they look like they can handle it. My Co2 is turned off for the last 2 weeks. The numbers in my feeding schedual are listed in ml's. LOL. For additives just stick to what the directions on the container say.

Do you actually raise CO2 levels to 3500 ppm during the last week of the feeding schedule before flushing? This question is based on your posted feeding schedule total ppm. Are the numbers listed in your feeding schedule in ppm? What conc. do you use for all other additives that you mentioned usng?

[noruas]

For what it's worth, to all CO2 Generator Piolet Light users, or would be users:


I have absolutely no troubble with my CO2 Generator, w/ Piolet light. It's in the middle of my grow room. The Light it gives off is very minimal, and no plants are showing any problems. Also, there is no negative effects associated with slightly higher CO2 levels during lights off. The piolet burner raises my PPM by about 100 above ambient air... so lights off CO2 ppm is around 500+/- ....


no problems at all, and I must say... CO2 kicks ass!!
never had such thick stems and rapid veg growth...
:rastasmoke:

[DB2004]

The PF2 is GARBAGE and does not work. I used to work for the company that made them. They have no power factor correcting ability, they're snake oil. IP Controls went out of business, the products were unreliable. I got fired for refusing to build them. I can answer any questions you may have on Flip Boxes, Timer Boards, Load Centers, etc......

Best Regards

DB

[jedeye]

Was wondering the price you paid for your AC unt and what cooling capacity it has. Any leads on where to find the one you used?

[Tranoble]

If you have no problem running lots of water and want to go cheap you can purchase a Chiller. they have 1 fan, 2fan and 3 fan maybe even 4 fan im not sure. I little bit more money and alot more power you can purchase a Thermoplus A/C they start at 1 ton and go up from there. Basicly 1 ton will cool about 3 1000w lights. If you want to spend even a little more money you can go with a A/C Heating and Cooling unit. These units have a condencer that sits out side and run gas to the A/C unit that sits in your room. They use alot of power but no water. You can do a search or ask your local hydro store about any of these and im sure you will find where to purchase them.

Was wondering the price you paid for your AC unt and what cooling capacity it has. Any leads on where to find the one you used?

[Tranoble]

Wow you use a pilot light burner in a sealed room and it doesnt raise you PPM of Co2 in your room when your lights are off. First i heard of that.

For what it's worth, to all CO2 Generator Piolet Light users, or would be users:


I have absolutely no troubble with my CO2 Generator, w/ Piolet light. It's in the middle of my grow room. The Light it gives off is very minimal, and no plants are showing any problems. Also, there is no negative effects associated with slightly higher CO2 levels during lights off. The piolet burner raises my PPM by about 100 above ambient air... so lights off CO2 ppm is around 500+/- ....


no problems at all, and I must say... CO2 kicks ass!!
never had such thick stems and rapid veg growth...
:rastasmoke:

[rollin500]

this thread is inspiring and very helpful, i've reciently gotten into the scene with some equipent I ordered from BC, i'm doing 20 clones per 1k hps and 3 in the flowering room, so 3k and 60 little guy's under 12/12 how do u think they'll do WITHOUT CO2? what am i looking at to set it up? And how bad do u think it will stink, should I invest in a charcohol setup?

[Tranoble]

First off if your just starting out read this whole thread. Pretty much help you step by step. To run Co2 you will need a Co2 burner with a glow plug and a Co2 computer/monitor. Burner will cost you about 6-8 hundred, and the computer are about 650-1150. I just bought one from Better Than Nature for $650. If you cant afford it this time around make sure you invest in the Co2 next time around. Its sure worth the money it will increase your yeild big time. For the charcoal filter I would wait. You dont have very many plants and it depends alot on what strain you are using. Some stink more than others. If you need any help at all id be glad to help you. Just post any questions here on this thread. I check every few days. Good Luck.

this thread is inspiring and very helpful, i've reciently gotten into the scene with some equipent I ordered from BC, i'm doing 20 clones per 1k hps and 3 in the flowering room, so 3k and 60 little guy's under 12/12 how do u think they'll do WITHOUT CO2? what am i looking at to set it up? And how bad do u think it will stink, should I invest in a charcohol setup?

[rollin500]

yep i've been reading this thread for day's now but for a newbie I think i'm doing very well with my show so far, i'd like to post you some pics but I don't have a digi cam right now. I'd say after the first round or so i'll try to invest in a co2 system but u know how it is when u first start out, how tall would u recommend I veg them before flipping 12/12?

[jedeye]

How do you determine total ppm from the feeding schedle you posted to be sure that you are using the proper CO2 levels. You poste the schedule in mL added, right LoL? Could you post a CO2 schedule as well or explain how to calculate CO2 levels from the feeding schedule that you posted. Different EC meters seem to have different formulas for calculating ppm levels and converting to EC readings. Hope I wasnt too confusing. I am doing lots of research concerning this thread. It woke me up to what is possible with using a little inginuity.

Thanks Again for your generosity.