when i was in high shcool my friends and i would make a little water pipe out of a soda bottle. it's pretty easy. you need a 20 oz soda bottle, a straw or 2, and someting hot(we always used a lit cig),some tin foil and duct tape and maybe a wire coat hanger. take the top off the soda bottle and burn a hole in the cap (this is whereyou might want a wire coat hanger, you heat the hanger over a lighter then use that to burn a hole through the cap) that a straw will fit through.then you need two holes in the side, one toward the top of the bottle that will fit a straw to take your hits through and one in the middle or so for a carb. fill the bottle with water level you want, put a straw through the cap so that when you put the cap on the top of the bottle upside down the straw will reach the water ,then duct tape the top to the bottle. take a straw cut in half and stick that in the hole you burn in the top part of the bottle. all you have left to do then is take a peice of tin foil and in the inverted cap and poke some holes in it. that's your bowl. be sure to tape it good so that you don't get a lot of air leaks. of course these types of water pipes don't last long the cap will start to melt and it will start to taste nasty. you'll know when you need to make a new one. that's the only type of water pipe i know how to make. there are plenty of options out there otherwise though. tin foil pipes, apple pipes, soda can pipes there is a web site that shows how to make these. it's www.smokingwithstyle.com under pipe etiquette. hope that helps. somewhere on that web site it shows how to roll a j and a blunt too. i think it's a pretty good website.
toke on
LeLe420