Oh why didnt I post here and get Zanders advice "before" I started?!?!

Hopefully I will have all 3 doors sanded, hung, level, able to freely open/close; by tonight. In fact, Im headed out to work on them right now.
If so, then I'll be able to add the doorstops and weatherstrips.

Once that part is complete; while its cooler at night, I'll finish connecting the exhaust fans in the attic.

This weekend should be: put in the shelfs, finish cutting the pvc tubes and setting up the system.


****
I still need to know if airstones in the res tanks (30 gal) and 2 in each pvc tube (3' long x 6" wide) is enough air??
I should point out that I do not have the pumps for the airstones in the tubes yet. (that will be after first harvest)
So as of now, I only have airstones in the res tanks.

I did buy more fans. So now each section will have:
Exhaust fan at the top
fan on the lamp
fan directed over the top of the plants; circulating air.

Im fairly positive overheating will not be an issue, but I am concerned about fresh air. (this system is air/light tight)
Cameltoe Reviewed by Cameltoe on . My Setup..stuck I started out with this great vision... then I smoked. :eek: My setup is three sections at: 3x3x9 the walls are 7 layers thick.. 1.) White paint on the inside (additive: Heatshield R-20) 2.) Particle board 3.) Heatshield III 4'x250' *roll* (used for its heating/cooling properties; not for reflectiveness) 4.) Insulation 5.) Heatshield III Rating: 5