nobiee420 - thanks

sheist - I dont really know electricity...hopefully I can get some more help; when I get to that part.

Zandor - I do have the door stops and weather stripping. Just not installed yet. (been wasting alot of time re-hanging the doors)
The pvc design is alot like the following pic. im going for four 6" pvc tubes side by side, in each section; (on a shelf 2' up from the floor) with the water tank below the shelf.
The idea was to move each tube into the next section...but would it be easier to just move the lights? (from blue to red/flower)
pump the water up to each pvc tube. will be slanted slighty for water to flow. Then drain straight down back into the res tank.
I have the design in my head; sort of...but putting it together has got me at a standstill atm.

Im not sure how I could come so far with Project 420 to just get stuck now...Im hoping you guys will be able to kick me in the ass; so I can get back to work onit.
Cameltoe Reviewed by Cameltoe on . My Setup..stuck I started out with this great vision... then I smoked. :eek: My setup is three sections at: 3x3x9 the walls are 7 layers thick.. 1.) White paint on the inside (additive: Heatshield R-20) 2.) Particle board 3.) Heatshield III 4'x250' *roll* (used for its heating/cooling properties; not for reflectiveness) 4.) Insulation 5.) Heatshield III Rating: 5