If you've got a good amount of resin, try smoking bots...but don't try it if you don't smoke cigarettes already...

Get a 2liter (or smaller, if you can't handle it) plastic pop bottle. On the bottom, where it comes down to 5 points (so the bottle will stand up), melt away one of the points with a lighter. Try not to burn the plastic, if you're careful enough you can melt a 2cm hole without it bubbling and turning black. Now, screw the lid on.

Arrange your resin in small balls. Smaller than that. These have to be small enough to fit on the glowing cherry of a lit cigarette.

Light the cig, and give it a few puffs to get the heat nice and high. Blow on it real hard so that the ashes are cleaned off, then carefully drop/press the resin ball onto the cherry. As soon as the resin is on the cherry, put the lit end of the cig into the hole you melted. Keep holding the cig, and let the bottle fill with smoke, but not too long...remember, it is a cigarette, and you're trying to smoke the resin. Once the resin ball is completely gray (ashes) CAREFULLY remove the cig from the bottle so you don't get ashes inside, and take off the cap and inhale.