blunts

[Porkchop913]

whats the eziest way to make a blunt lol and im not that good at rollin either

lol need blunt for blunt day.

Porkchop913 Reviewed by Porkchop913 on 07-14-2005. blunts whats the eziest way to make a blunt lol and im not that good at rollin either lol need blunt for blunt day. Rating: 5

[Porkchop913]

come on ppl help me

[Killa.Kali]

its best tought in person, its hard to teach how to roll good fatties on the net =\ i tought myself how to roll (basic shit) on my own with a pack of Bugler tobacco, then my friends tought me their little tips and finer techniques

[Porkchop913]

do u like cut it open or unpack it or what

[red662]

yea u cut it take the inside out fill it with weed beein careful roll it and stick it and puff puff smoke

[Porkchop913]

so cut it down the middle rt

[Killa.Kali]

ya, with a straight razor and a steady hand cut right down the middle, the tobacco shouldnt be hard to brush out with a quick swoop of your finger

[Porkchop913]

k thx kali

[Killa.Kali]

np lol red explained more than i did, just remember that joints/blunts have only 2 true necessities - good rigidity and a tight seal, other than those the rules are up to u

[Hydrizzle]

OK here is a guide from the resident blunt guru.

1) use natural leaf wraps. You will know if the blunt has visible veins in the leaf. Good brands are dutchmaster, garcia y vega, and some other not so popular ones.

2) Lick the blunt (or lightly trickle water over it-- licking is better) untill it is shiney with moisture.

3) use a sharp knife or sharp fingernail (i dont have those ) and cut the blunt cleanly down the middle.

4) Push all the tobacco out, and cut out the "cancer paper" as I call it (the half inch or so near the tip)

5) place weed tapering from not much weed in the tip, to more in the end, making a cone shape or "spliff" (this gives greater flavour)

6) two ways to roll it, the way I do it is to place it on a table, fold the flap over the weed, and pull it back, compacting the weed. Then, fold the flap that is sticking out over the flap you just folded, making a tight even blunt.

the way some of my friends do it, is to hold the blunt in the air, and make several tears in the flap, rolling it a section at a time. My way is easier i think, but both work fine.

7) dry the blunt with a lighter, so its not wet to the touch, light it up, and enjoy!