Here it is ... I posted these in another thread, but thought I'd share them with everyone by making them a little easier to find.


I built my growroom using 3/4" PVC and draped the frame with panda plastic (black on the outside, white on the inside. Am going to add a roll of mylar down lower to cover the bottom of the plants better. I used a half a sheet of 1/2" plywood for the floor -- I strategically placed extra PVC under the floor for extra support. The room is about 4x4x7 1/2. I grew 3 large plants in there with room for another. So far your into it for about $50.00 bucks, depending on if you can salvage some board for the floor.

I used two 5' pieces of dog chain (about $5 for chains and hooks) and some 's' hooks to hang the lights from (that was the only expensive part--the lights that is)

I mounted (ingeniously I might add) a 100 CFM bathroom fan (you can get a fan for about $13 -- I spent more on a good one like $50.00) to continuosly vent the room -- the plastic wasn't secured at the bottom, plus the front flap seemed to provide adequate air intake.

Finally, I took a house fan we already had and stuck it in there -- blowing whever the light was on. I just upgraded to a standing fan, with random variable speeds ($40.00). I like the 2 and a half foot vertical flow it puts out.

If you go with cheap fans, you can do the room for under $100 easy. Use any extra plastic to make a liner for the floor. Tape it to each corner -- in case of spills.
OR Freebird Reviewed by OR Freebird on . Pics of my $100 growroom Here it is ... I posted these in another thread, but thought I'd share them with everyone by making them a little easier to find. I built my growroom using 3/4" PVC and draped the frame with panda plastic (black on the outside, white on the inside. Am going to add a roll of mylar down lower to cover the bottom of the plants better. I used a half a sheet of 1/2" plywood for the floor -- I strategically placed extra PVC under the floor for extra support. The room is about 4x4x7 1/2. I grew 3 Rating: 5