Results 1 to 2 of 2
-
05-04-2004, 12:21 AM #1OPJunior Member
cutting back
i have numerous plants growing in a hydro system under 600 hps and 10 4ft. floros on the walls in a 5'x2' space wit the light about 1ft 5in above the tallest plants.....some are smaller than the others but i cant do anythin about it. and im about to change to 12/12 in a few days......well they are real crowded and some leaves at the bottom arent gettin enough light to them and dying but 95% of all the rest are beautiful.....is this ok that they are so crowded? do i have anything to worry about? strain is ak47. would i get less yield if i cut the leaves that are crowded up against the walls and each other? i would clone but i have no space to put them. anyways, thanks for any help given.
smoke1fla Reviewed by smoke1fla on . cutting back i have numerous plants growing in a hydro system under 600 hps and 10 4ft. floros on the walls in a 5'x2' space wit the light about 1ft 5in above the tallest plants.....some are smaller than the others but i cant do anythin about it. and im about to change to 12/12 in a few days......well they are real crowded and some leaves at the bottom arent gettin enough light to them and dying but 95% of all the rest are beautiful.....is this ok that they are so crowded? do i have anything to worry about? Rating: 5
-
05-05-2004, 07:31 PM #2Senior Member
cutting back
Start flower cycle and cull the males as they show themselfs before you start cutting plants.
Good Growing!
Advertisements
Similar Threads
-
cutting back
By Jake420 in forum GreenGrassForums LoungeReplies: 8Last Post: 09-04-2007, 07:37 PM -
Cutting back
By turksteelman in forum Indoor GrowingReplies: 4Last Post: 07-11-2007, 06:24 PM -
cutting light back prior to setting starts out
By krazy2006 in forum Outdoor GrowingReplies: 2Last Post: 03-24-2007, 06:59 AM -
cutting back
By naturalhigh in forum GreenGrassForums LoungeReplies: 8Last Post: 09-27-2005, 07:35 PM -
im cutting back
By BOgart.bitch in forum GreenGrassForums LoungeReplies: 19Last Post: 03-22-2005, 03:32 AM