Results 1 to 9 of 9
Hybrid View
-
06-17-2005, 07:37 PM #1OPSenior Member
sealing
Is Duct tape ok to use to seal the bowl to the shaft, or will it melt? If I can't use duct tape, what should I use?
NightProwler Reviewed by NightProwler on . sealing Is Duct tape ok to use to seal the bowl to the shaft, or will it melt? If I can't use duct tape, what should I use? Rating: 5I do not smoke/use/posess marijuana and i never will
-
06-17-2005, 07:44 PM #2Senior Member
sealing
Electrical tape is good but id use a Hot glue gun...less cemicals
-
06-17-2005, 07:45 PM #3Senior Member
sealing
Chemicals*
-
06-18-2005, 01:23 AM #4Senior Member
sealing
yea electirical tape is the best shit.....
-
06-18-2005, 01:53 AM #5Senior Member
sealing
Gaffers tape will stand up to some SERIOUS heat. Much more than anything your bowl will put out. It's kind of a pain in the ass to find, probobly have to order it, but its the perfected duct tape.
-
06-18-2005, 03:30 AM #6Senior Member
sealing
If u cant find Gaffers Tape Electrical Tape Is ur Next best thing.
-
06-18-2005, 02:15 PM #7Senior Member
sealing
Gaffer's tape is available on eBay.
-
06-18-2005, 11:06 PM #8Senior Member
sealing
There you go, I've never had to buy my own, but I've also never seen it in any stores. Sounds like ebay is probobly the easiest, unless you know people in the theatre buisness.
-
06-19-2005, 02:22 AM #9OPSenior Member
sealing
yea i just used electrical tape and tried it out... worked fine and didn't melt.
I do not smoke/use/posess marijuana and i never will
Advertisements
Similar Threads
-
sealing joints shut
By delukssteelcityscum in forum Marijuana MethodsReplies: 4Last Post: 12-25-2006, 08:25 AM -
Is there such thing as vacuum sealing a bag too tight?
By Meenstreek in forum GreenGrassForums LoungeReplies: 4Last Post: 12-10-2006, 11:11 PM -
Sealing Off Heat With POLYCARBONATE Instead Of COOLTUBES
By faithless in forum Indoor GrowingReplies: 5Last Post: 11-26-2006, 03:52 AM -
door sealing question
By AmazingBlazing in forum Closet / Cabinet GrowingReplies: 3Last Post: 07-06-2006, 01:41 PM