Ok so I bought alot of materials I'm gonna post some pics here I set up my perm starter seed/clone cab for fun and just for a little something extra, I'm putting up a wall it will partition off 8.5x17 for me to play in, I have all the stuff I'm starting construction this week, I'm thinking at this point of three or four rooms since I wanna do vs. And experiment it will give me lots of rooms, it'll either be 3- 5.5ishx8 rooms or 4- 4ishx8 rooms, so I can do two veg and two flower, as far as actual use if u thin about it I was thinking a 2 ft wide walkway(lol sideways walk anyway) shaving the 8ft depths down to 6ft, I'm gonna run four inch ducting throughout with an intake and exhaust both carbon filtered(ill post u guys have to see my homemade carbon filters they are AMAZING!! easy, and dahm near free!!! Oh refillable and last forever!!) Multiple hang downs attached in each section for suction y'd to the lights to pull the smell and heat at the same time out and up my chimney, it will have four fans and four vents two from one end to the other through the lights with the hang downs to suck out the smell ill run probably 100ish cam's on each end with boosters in between just because of all the openings, then a fresh air draw in near the ground to another vent at the far opposite end up the chimney as well just for exchange, I'm running a co2 tank system, I haven't decided for sure on lighting yet I could use some input on the room size to wattage thing for Max yield, I'm thinking of housing anywhere from 5-20 plants depending on method in each room, I'm gonna line the whole deal with panda, as well as partition my rooms with it folded for light separation, now as far as lights go if they are only potent in so many sq ft per watt wouldn't it be best to maybe do panda up against where the pots start so the open walkway isn't a waste of light and decreasing plant concentration!?? Humidity is about 55% give or take and temp STAYS a steady 70°f but I'm sure light and vent systems will change that a little but I'm running a bunch of meters and stats to keep things very consistent and low stress I'm gonna start a sog in one room with give or take 15-20 flip lights to flower pull my males clone my females and I'm thinking of putting 4 or 5 under a scrog set up and the rest to veg again in sog help me out here!!! I want input!! Anyone wanna see a particular side by side!? Any suggestions on light!? Vents!? Panda film!? Anything!? Anything at all!!!??? Three rooms or four? One scrog room or two to alternate? One sog veg room to flower beside the alternating scrog that's flowering or a delegate room for them(that's where the three or four rooms comes in) come on people as for now the first sprout I had is moving beautifully with her second set of leaves hers some pics of the set up for now...
Indimaniac Reviewed by Indimaniac on . Anyone wanna see a specific x vs x? Ok so I'm going to use this as an actual log for my start up with new construction so bare with me there may be some time between postings but I'm hoping I can get some feed back from the community, I'm gonna set up a grow room with 3 stations a fair size veg room for side by sides until I find my absolute perfect set up I'm not scared of mess ups so we can have some fun here! A flower room, and a small shelf or work bench in one of the rooms for germ/clone, prep, tools, etc... I for now I'm Rating: 5