i'm about to make an update video for you guys right now. I tied them down and changed plans in the middle so they're still in veg. Until I feel like they look right. I was going to tie one plant in a big tight cirlce, like tie it with some yarn into one huge cola. It would be like 4 or 5 branches all equal height clipped trimmed. The bottom bare just the top branches with leaves. all even, tied up and staked. But if I did one like that , the other would have to be the same. I have one plant low and bushy and one high and tight. SO I just made them both bushy. I had to tie the tall one down to make it bushy.

I tied it like 5 times to make it short. Now they're even, I need to make a screen thing to hold them, it's called a scrog grow. I was gonna use a garbage can. On a garbage can you can flip it upside down, paint the inside flat white and have a nice easy led, no heat grow room. You don't Even need a vent just air it out once a day. LEDS are completely heat free right? My LED flashlight never gets hot.

Might still do that trashcan Idea. I'll use a small hole for air with a cpu fan. Lollipop the plant scrog them in the trashcan. Cut holes in the trash can sides with a soldering iron when I need to raise the cages. Use enough string to seal the holes and use white caulk to seal the light.
Small hole at the top and I buy A shit load of dryer or , see if I can find smaller duct work. Then wrap that shit in circles as many times as I can and it should be light tight. Like circle it at least six times in circles the size of the trashcan bottoms, or for me tops.
I can use one trashcan for each plant 6 cfls on top 6 on the sides and bottom for full lighting effect no shadows at all.

Cheap digital temp gauge. That should cost me like 15 for a quality hard big outdoor trashcan, maybe costco has a sale?
WHite paint is like 5 bucks for a big ass can, never use spray paint it creates dust that gets all over your shit. Flat white in a can is best.Attachment 285284 Use some sand paper to scratch the inside of the can or use a brillo pad and soapy water to wet sand it.

Buy string or yarn for like 5 bucks to make the screen for the scrog. I have a soldering iron, 2 kinds electric and butane. Hydro would work easy in that too. I'd use the lid, I will use the lid in this grow.
jiggsaw Reviewed by jiggsaw on . Desert sun grow / cfl 284168284169 Rating: 5