.....one standard garage 20x20x8 2x4 construction plywood roof no insulation 1/2 ply and tar paper plus siding heat cool value equals 0. that's where we will start. garage door insulated from factory motor and drive removed. total amp draw for garage 100amps 10,000 watts. installed recepticals 4 @120 1@240 split 50a 20a 3a0 breakers installed.
.........hole room covered in black and white poly sealed with construction silver aluminum tape with zipper doors in spots needed and a light blocker door for the entrance.
........intake cooling is a swamp located and east end of garage approx 3 ft of ground in middle placing pluntum at 4 ft distributing air in all four directions through 10x 10 intake sides and filters removed and put in a box built around the window drawing cool fresh filtered air from outside air sealed and insulated covered with poly 1400cfm cooling temp at winter 40-50deg about 42,000btu
.......... exhaust carbon located 1 foot from south garage on floor on center to pull co2 and other room elements through the plants thoroughly at 5 time a min to achieve optimal co2 and cooling canopy height and light height with 12ho through a 12 corona discharge 03 with muffler out at 1100 through to achieve positive static co2 build up.
..........4 16in fans 2 each on center from lights 50in 2 foot off ground 1 foot from plants reaching across canopy air layering circulating co2 o3 and carbon while a 6ho carbon filter with muffler cools and circulates air in upper two foot of room where ballast top of hoods and o3 generators in center of canopy are located.
..........with the co2 gen lpg 10 burner is located in front of 1400 cfm to domantly circulate the co2 2ft from ceiling and 2 foot from 1400cfm 2ft from light source and plants canopy.
.........lights 8 1000 switchable 240 hps and parabolic located at 4ft on center on 50in centers and ballast at 2 foot from top of room 6in from wall on north shelf being directly cooled by 6ho with operating peak temp of 85 deg controlled by a hph8 and mdt1 sentinel automation products also cooled in same location evc2 nd1 co2 pxm120 pxm240 fan speed controls ect..
to be cont soon.......just begining NOF out.........
Native¥organicfarmer Reviewed by Native¥organicfarmer on . my grow room specs. .....one standard garage 20x20x8 2x4 construction plywood roof no insulation 1/2 ply and tar paper plus siding heat cool value equals 0. that's where we will start. garage door insulated from factory motor and drive removed. total amp draw for garage 100amps 10,000 watts. installed recepticals 4 @120 1@240 split 50a 20a 3a0 breakers installed. .........hole room covered in black and white poly sealed with construction silver aluminum tape with zipper doors in spots needed and a light blocker Rating: 5