my grow room specs.

[Native¥organicfarmer]

.....one standard garage 20x20x8 2x4 construction plywood roof no insulation 1/2 ply and tar paper plus siding heat cool value equals 0. that's where we will start. garage door insulated from factory motor and drive removed. total amp draw for garage 100amps 10,000 watts. installed recepticals 4 @120 1@240 split 50a 20a 3a0 breakers installed.
.........hole room covered in black and white poly sealed with construction silver aluminum tape with zipper doors in spots needed and a light blocker door for the entrance.
........intake cooling is a swamp located and east end of garage approx 3 ft of ground in middle placing pluntum at 4 ft distributing air in all four directions through 10x 10 intake sides and filters removed and put in a box built around the window drawing cool fresh filtered air from outside air sealed and insulated covered with poly 1400cfm cooling temp at winter 40-50deg about 42,000btu
.......... exhaust carbon located 1 foot from south garage on floor on center to pull co2 and other room elements through the plants thoroughly at 5 time a min to achieve optimal co2 and cooling canopy height and light height with 12ho through a 12 corona discharge 03 with muffler out at 1100 through to achieve positive static co2 build up.
..........4 16in fans 2 each on center from lights 50in 2 foot off ground 1 foot from plants reaching across canopy air layering circulating co2 o3 and carbon while a 6ho carbon filter with muffler cools and circulates air in upper two foot of room where ballast top of hoods and o3 generators in center of canopy are located.
..........with the co2 gen lpg 10 burner is located in front of 1400 cfm to domantly circulate the co2 2ft from ceiling and 2 foot from 1400cfm 2ft from light source and plants canopy.
.........lights 8 1000 switchable 240 hps and parabolic located at 4ft on center on 50in centers and ballast at 2 foot from top of room 6in from wall on north shelf being directly cooled by 6ho with operating peak temp of 85 deg controlled by a hph8 and mdt1 sentinel automation products also cooled in same location evc2 nd1 co2 pxm120 pxm240 fan speed controls ect..
to be cont soon.......just begining NOF out.........

Native¥organicfarmer Reviewed by Native¥organicfarmer on 02-21-2012. my grow room specs. .....one standard garage 20x20x8 2x4 construction plywood roof no insulation 1/2 ply and tar paper plus siding heat cool value equals 0. that's where we will start. garage door insulated from factory motor and drive removed. total amp draw for garage 100amps 10,000 watts. installed recepticals 4 @120 1@240 split 50a 20a 3a0 breakers installed. .........hole room covered in black and white poly sealed with construction silver aluminum tape with zipper doors in spots needed and a light blocker Rating: 5

[Native¥organicfarmer]

8k 50amps/240 hid light start marijuana medicinal edibles grow. - YouTube quick link to my garden.

[Native¥organicfarmer]

And no tax....... :-)_ This is an LG Art Cool 36,000 BTU 9+9+9+9 Quad Zone Heating and Cooling System. It features four (4) 9,000 BTU Art Cool in Mirror Finish indoor units and one outdoor unit. Each indoor unit features the Plasma Air Purifying System and is controlled by a seperate remote control. The flexibility of a dual, tri or quad zone helps to assure the proper selection of equipment to achieve maximum results. They are ideal for nursing homes; doctor's offices; condominiums, apartments and residences - any place where individual cooling or heating and improved air quality is needed.


Multi Power System Energy saving twin compressors: one provides power at 60% capacity until the system reaches a desired temperature, then the smaller compressor takes over to provide sustained operation at 40% capacity. This unique energy saving feature is only available on select LG Mini split Units

Ultra-Quiet Streamlined Air Fan - Interior units have a cross-flow fan that operates at low speed but generates more air. Special fan housing creates smooth, quiet air flow and the unit's low-voltage DC motor operates with minimal noise.

Purifying System - An electrostatic filter removes dust, pollen and smoke; an anti-fungal filter prevents bacteria and mold from forming; and a deodorizing filter constantly freshens the air. Dehumidifying Mode Indoor unit accurately senses room temperature and controls humidity by shutting down compressor(s) before a room is over-cooled.

Standard Features of the LG Art Cool Quad Zone Heating and Cooling System 9+9+9+9
Multi Power System
R-410A Refrigerant
Plasma Air Purifing System
Triple-Filter Air Purifying System
Self-Cleaning Indoor Coil
Dehumidifying Mode
Chaos Swing
Jet Cool
Three-Way Cooling
Cooling Mode
Heating Mode
Defrost Control
Fan Mode
Auto Operation
Manual Power Switch
Temperature Display on Indorr Unit
Auto Sleep Mode
Auto Restart
24-Hour On/Off Timer
Evaporator Frost Control
Ultra-Quiet Operation


The Solution is Clear!
Cool only the areas you want and not the areas where you are not
Individual zoning at the push of a button, putting you in total comfort control
Less then 5% cooling loss occurs in insulated refrigerant lines versus up to 40% through ducts
Requiring just a 3 to 4" diameter hole in the outside wall means less mess, better home aesthetics, and improved security, unlike a window unit
LG models mount high on the wall so they don't disturb your view
LG units add value to your home and are more efficient than old window units, saving you money
LG Quad Zone H36AM (9+9+9+9) Art Cool Wall Heat Pump AC 18 SEER - 36,000 BTU (3 Ton