Ive read the forums and many other sites' info. Just want experienced advice. I am wanting to start my next grow in March and was thing of using an ebb and flow setup using: 2, 10"Dia x 4' L, PVC Tubing with 3, 6" holes per tube for netted pots. 6 plants total. The tubes would set 2"-4" higer on one end to allow for drainage into a 20 gal Res., pumping nutes at a constant drip rate of 1 gph. Under 2, 600w HPS. Any input or advice to this setup is greatly apprecieated. My other option would be a 6 pot DWC setup, using a 20 gal res as well as the 1 GPH constant drip. I am unsure of the constant drip, is this too much? Should I change to 1/2 gph drip on constant?

My current grow is DWC: No drip, but pumps (un-regulated) on a cycle of 15 min on, 2 hour off, and Im not sure of the un-regulated pressure of the pump. I got it from Lowes for $20. Its for a "Pond Fountain." Plants arent showing any signs of nute burn, lock-out or stress, any advice here?

Ill post pics this week showin current set up and a few drawn up Diagrams of my next setup.
killfrenzi Reviewed by killfrenzi on . Ebb and Flow Setup Advice? Ive read the forums and many other sites' info. Just want experienced advice. I am wanting to start my next grow in March and was thing of using an ebb and flow setup using: 2, 10"Dia x 4' L, PVC Tubing with 3, 6" holes per tube for netted pots. 6 plants total. The tubes would set 2"-4" higer on one end to allow for drainage into a 20 gal Res., pumping nutes at a constant drip rate of 1 gph. Under 2, 600w HPS. Any input or advice to this setup is greatly apprecieated. My other option would be a Rating: 5