no blabbing all info helps...im leaning to too much fert as well.the reason i dont list temps ,ph humidity is cause theyre all right on. humd about 30. temp 78, ph 6.0 or little less........so DD11 its not the ph..i personally think its lockout but whenever i use a 7-800ppm max or a weak solution so theres no tip burn sometimes i dont even get buds ...just stays in veg. its like if i dont burn/ hammer them ,,,,they dont respond. basically ive been doing what CGI suggests. more ppms...... ive tried less no burn ,,,,no luck but no consistency or understanding of whats really correct. im looking for someone who.....knows someone that has done drain to waste 6x6 ROCKWOOL cubes and what recipe was used. can anyone direct me to someone steeped in this knowledge.
Lazy Haze Reviewed by Lazy Haze on . more nutes or less with blue widow im using 6 x6 rockwool cubes. hand watering drain to waste. 1000w hps in doors. 18 days into flowering. Gh flora. at 1 micro to 2 bloom ratio no grow. 1/4 tea per gallon of powder koolbloom. mixed to 1000 ppm at the present time. do these plants need more ppm or less? more nutes? are they getting burnt? any help much appreciated. im asking because gh's nute calculater says that you should not go over 850ppm. i did that for the first few weeks and just a few days ago went to 1000ppm when i saw Rating: 5