Looking at the pictures this must be a low wattage ballast? The wires are fairly small, or at least appear so in the picture.
In the first picture the plug in must plug into the ballast and then the other end you wire into the light socket. It appears to be an odd socket design too. Are you in europe?
That ia also a very odd ballast to have so many wire hookups on it. Usually there would only be 3 wires unless it was a 220v ballast.
killerweed420 Reviewed by killerweed420 on . Need help with connecting the ballast to the reflector/light! Hey, so here's the deal... I just bought a HPS lighting system which wasn't assembled when it came and had no instructions on how to put it together. I think i've managed to figure out how to set up most of it but there's one particular part I'm confused about. There is a lose wire that connects the reflector to the ballast (presumably) and on one end the live and earth wires are exposed, allowing me to connect it to the reflector, but on the other end the live and earth wires aren't exposed Rating: 5