first off thank you so much for sharing all of your tek and knowledge.
for all the interweb's info, wisdom is in short supply.
i have come up with a bit of a "huh/hmm" moment whilst pulling hash.
can naptha reach a saturation point when extracting?
i dont have reclaim ability when boiling off so i was getting bummed at evaping all that solvent off into the air.
so in the interest of efficiency in both cost and pollution, i am trying to figure out how much of a load can the fluid hold?
current way:
1. putting dried and crushed material into a 10k ml pyrex with enough warm solvent to cover.
2. shake for a minute and decant thru filter into warm salt saturated distilled water.
3. shake and allow to separate.
4. pour off appropriate layer.
5. warm till all solvent gone.
6. 99% iso and water wash till clear of petro chem scent.

can i reuse the same solvent on the next wash before evap?
if so how often or what is the load rate?

oh and as always, do you see any way to bring my methods up to at least jr skunk standing?
we ingest 50% and vape the rest.
thank you for your help and direction!
satchmo Reviewed by satchmo on . question for uncle graywolf first off thank you so much for sharing all of your tek and knowledge. for all the interweb's info, wisdom is in short supply. i have come up with a bit of a "huh/hmm" moment whilst pulling hash. can naptha reach a saturation point when extracting? i dont have reclaim ability when boiling off so i was getting bummed at evaping all that solvent off into the air. so in the interest of efficiency in both cost and pollution, i am trying to figure out how much of a load can the fluid hold? Rating: 5