Results 1 to 10 of 12
-
02-06-2011, 03:32 AM #1OPMember
WHITE MILDEW POWDER MOLD
ok i just spotted it on like 2 leafs lower one's
what is the best CHEAPEST!!! solution i can use to wipe down the leafs and stem's im going to bleach the grow room
Should i run my vent van (not the one next to the plants) at night
AND it get's really cold right now at night and its out in a garage so its not easy to heat up whats best :rastasmoke:420atsk Reviewed by 420atsk on . WHITE MILDEW POWDER MOLD ok i just spotted it on like 2 leafs lower one's what is the best CHEAPEST!!! solution i can use to wipe down the leafs and stem's im going to bleach the grow room Should i run my vent van (not the one next to the plants) at night AND it get's really cold right now at night and its out in a garage so its not easy to heat up whats best :rastasmoke: Rating: 5
-
02-11-2011, 08:17 AM #2Senior Member
WHITE MILDEW POWDER MOLD
I use serenade, treat all my clones and vegging plants once a week.
You can even use it up to the day of harvest. It's a systemic problem usually strain specific, so if you treat them through all stages, it won't be a problem come flower time.
stay green! :jointsmile:
-
02-11-2011, 12:39 PM #3Senior Member
WHITE MILDEW POWDER MOLD
Try Skimmed Milk, Not Whole Milk as the fat in it can go bad...
Cheep and works like a charm...
-
02-11-2011, 05:45 PM #4Senior Member
WHITE MILDEW POWDER MOLD
Skim milk spray or sulphur burner.
-
02-11-2011, 11:07 PM #5Senior Member
WHITE MILDEW POWDER MOLD
Originally Posted by Duke420
You want to kill it or battle it??
you need to get some eagle20 and spray 100% of your plants... 100% total coverage
then aero bomb your grow room with fungaflor this will kill any spores that are present on your walls... ceiling... equipment ect...... like a sulfur vape does only no rotten egg smell.
Only final thing to do is to filter your incoming fresh air... if possible
-
02-13-2011, 05:13 PM #6OPMember
WHITE MILDEW POWDER MOLD
thnx it has not broke out again yet but its ok to just spray the whole plant and let it drip in the dirt and all ive been wiping every spot so far and hit what i could around the tent
-
03-18-2011, 03:25 AM #7Junior Member
WHITE MILDEW POWDER MOLD
Serenade is an excellent prophylactic measure, but it will only retard growth. A solution of 0.25% rosemary oil, or neem oil should do the trick. The nice thing about this is that it is also a pretty good miticide agent. Try Home Depot. About $6 per quart spray bottle. Milk contains lactose which can provide an excellent disaccharide for bacteria metabolism, so while it does work, it is not a great choice.
-
06-23-2011, 04:34 PM #8Member
WHITE MILDEW POWDER MOLD
I did some hard core research on PM. PM lives within the plant so sprays are not that effective. As soon as the leaves grow and make new surfaces the PM will come back. Sulfur burners are very effective but cant be used in late flowering.
Serenade like edwardschlosser said will only retard it it will not kill it. I don't think there is a cure for it no matter what manufactures say! Either make/buy a sulfer burner or destroy all affected plants and start over. I know it sucks but that's life. I had to throw away about 8 oz of SuperSilver Haze because the sprays made it smell and taste like crap. Serenade has a horrible smell so be careful where you spray it. Its best to use it in the bath tub then wash it all down when your done spraying. Most sprays have sulfur in it to fight PM. Sulfur as you know smells like rotten eggs and tastes worst.
Keep temps above 77 and keep humidity below 45% to limit how much it spreads. PM hates hot and dry. So at night yes you need to keep the blowers going otherwise humidity gets out of control. Its OK if the temps get into high 50's. If colder draw air in from inside your house.
A sulfur burner used early in flower can prevent PM. Sulfur burners coat everything in your room with sulfur so spores have no place to live. Sprays wear off and spores off walls and floors get to work. Burner coats walls and floors.
My last grow I had PM. I tried 5 sprays, none worked for more than a week. I wish I had just killed them all and started over cause it killed my yield and had a bad taste from sprays and delayed the next grow by 6 weeks. The PM gets deep into the plant. After harvest I cleaned my room with bleach and lots of it, every surface and every piece of equipment had to be decontaminated. I also built an air filter for incoming air. Out side of where I live is very shady and wet so most plants out side have PM. The spores had come in via my intake air duct. I am a week away from harvest on my 1st grow since the PM, and there are no signs of PM. SO if you decontaminate your room and filter the air you shouldn't get it again.Anything I grow is for personal consumption only. I never ever sell anything. I hate buying it, I hate people making money off me, when its so easy and safe to grow. It is a victimless crime because it never leaves my home.
-
06-25-2011, 09:56 AM #9Senior Member
WHITE MILDEW POWDER MOLD
The cure for PM is to innoculate the plant internally with a lactic acid mix or high sulfur compound.
There are inherent problems with this, as once you spy PM the simple fact is it's contaminated your crop. At this point the only chance you have is heavy chemical (and subsequent flushings) of sulfur and magnesium in an attempt to control and kill it from over-nutrition (which the plant should withstand.) This will affect the taste of your crop if you are not careful in managing the dosage.
Sadly, it is very difficult to control taste and potency when you get PM infestations.
-
06-25-2011, 05:49 PM #10Senior Member
WHITE MILDEW POWDER MOLD
insted of the sulfur burner and that nice rotten egg smell....try using a fungal bomb...FUNGAFLOR....1 can covers up to 1500 sq ft.....I used 1 can on a 500 sq ft area
Covers all areas just like a sulfur vape just no shitty smell.
I sprayed my plants with a mixture of 1/2 cup 3 % h202 and 3 scoops greencure mixed in a 32 oz spray bottle of water and I set off the bomb in the Grow area:thumbsup:
Greencure kills the spore on contact.....h202 raises the plants ph for 4-5 days internally within the plant...... to high for pm to live
You can also burn the pm out....temps in the high 90s kills pm....cool your roots
Advertisements
Similar Threads
-
Powder Mildew
By grandpa in forum Plant ProblemsReplies: 3Last Post: 02-21-2010, 05:13 PM -
White Powder Mold and Bud Rot.
By oldhaole in forum Plant ProblemsReplies: 4Last Post: 02-17-2010, 02:52 AM -
White powdery mildew/mold
By pozoutlooker in forum Medicinal Cannabis and HealthReplies: 4Last Post: 09-09-2008, 06:21 AM -
white powder mold
By howsyourroof in forum Indoor GrowingReplies: 4Last Post: 01-12-2007, 10:47 PM -
powder mildew???
By Mo. G in forum Plant ProblemsReplies: 6Last Post: 11-16-2006, 08:43 PM