New Blooooom Roooom - Northern LIGHTS HPS clones

[sexysmoker9]

New Blooooom Roooom - Northern LIGHTS HPS clones
I was wondering if anyone could give me some advice as to when I should put my lights 12/12 and get out of the 24/0 veg?

this is day 2 for the clones under a 600hps + 150hps Room has great ventilation.
my temps are always around 79 and my humidity is around 20-25%. is this ok for such new clones?

I spent lots a time on building the room and investing in quality product and I have great expectations.. some new friends to come along for the ride would be sweet.. I don't want to cut corners and obviously want max yields. I am open to all and every comment or suggestions from the boards community.

Thanks to all who guide me to an efficient productive grow. Id like to make the best out of my new bloom room and northern light clones.


experience - 3rd indoor, outdoor experienced

Equipment:
600w HPS + 150w HPS sunlight mini system (ballast built in)
Distance from tops? 150w 1 ½ - 2 ft 600w 3 â?? 3.5 ft
panda
Is there a consistent fresh air supply? yes
around 260-320 cfm exhaust inline fan
basic hps grow bulbs

medium:
pro mix
Size of container. solo cups will upgrade to 3gal grow bags soon

Your nutrients and water:
Source of water? city water
Method of checking water ph. need to get one
ph up â?? down

Using foxfarm grow big and big bloom, sledge hammer, Micro brew, and going to substitute foxfarm tiger bloom for HPK by roots line of products.

watering- feed -water- water
no additives yet, recommendations?

growroom:
Indoor
3.5 ft x 6ft x 7ft
temps are at 78.5-82 when both lights are on which is 24/0 at the moment, about a week or so of veg???

Your strain:
10 -Northern lights clones from VT.
About 2 1/2 weeks old from cuttings

sexysmoker9 Reviewed by sexysmoker9 on 01-15-2011. New Blooooom Roooom - Northern LIGHTS HPS clones New Blooooom Roooom - Northern LIGHTS HPS clones I was wondering if anyone could give me some advice as to when I should put my lights 12/12 and get out of the 24/0 veg? this is day 2 for the clones under a 600hps + 150hps Room has great ventilation. my temps are always around 79 and my humidity is around 20-25%. is this ok for such new clones? I spent lots a time on building the room and investing in quality product and I have great expectations.. some new friends to come along for Rating: 5

[sexysmoker9]

the drying process
what a tediouse job, trimming
what do you guys think about yield.. 3-4 zips.. ?

[sexysmoker9]

i'll give a good yield/smoke report as soon as they are fully ready for jars...
shouldn't be much longer as the buds are airy and will dry fast..

any guesses???

[seventhchild]

looks like you harvested early......did you look at the trics with a mag ??

[sexysmoker9]

day 50 of 12/12 they look beautiful. going to start the flush process soon..
they have a great smell to them but the lower branch ones look and smell better. did a
lift on the light, it was a bit close.
what do y'all think?

[bubbels]

what are the result in grams or oz?

[SIMFER]

For vegetative stage is better to use MH lights and for flowering are HPS will do best. As far as how long you need to keep your clones in the vegetative state it's really up to you. Technically you can flower your clones right away because genetically they are the same age as the mother plant which is usually is the plant that is ready to flower. So if you have a lot of clones(30-50) you can make SOG (screen of green): you take 3" or 4" ABS plumbing pipes, cut them in length foot or foot and a half fill them up with your grow medium and plant your clones in them. Than place all of them in one or two storage containers about 4x5x2 and flower them. You will get a lot of small plants with huge top buds. Or if you want them to grow in the vegetative state it would be up to you how long you'll keep em in that stage it depends on the size you desire. Theoretically this type of plans will stay in the vegetative state for many years as long as they receiving continius supply of light no less than 18hr a day. Good luck!:jointsmile:

[SIMFER]

Usually 8 weeks of vegetative grow is enough. :thumbsup:

[tevfik]

Good setup.
Since you are open to all and every comment or suggestions, I can come up with some.

First raise the humidity some how. I'm not familiar with clones but 20-25% is low for normal vegging and must be harder for the young clones i think.
You can start with removing those unused big soil bags. They'll suck up humidity instead of plants. Best way is a humidifier but, if you're out of budget, you can use wide water tray/s filled with water. Wet towel, or some other things can be used as well.

600hps not needed at the moment IMO. Lights distance looking high. You can keep it closer. Still, I am not familiar with HPS but looked too much and high to me. (Using only 150W now also helps raising humidity)

Your medium have everything in it and looks strong/dangerous for young plants. You must be careful in the beginning (Whenever I see "allmix", "fullmix", "supermix" or similar, i think like this).

Looks like you don't need to feed for a long time. Maybe clones need some rotting nutrients? I don't know. And again i don't know how suitable is this medium. Maybe you can attach labels photo/info instead of brand

Are you planning to veg just a week? Say month.

By the way, i am not an advanced grower either. Consider this.

Good luck :thumbsup:

[seventhchild]

promix has NO nutes ,it is a soilless medium , all food will be provided in the water.the question is "how tall before i flower?".just eyeballing the # of plants you have to put in a 3 1/2' space i'd say 8" to 10" with mature plants finishing at 20" to 36" tall... some thinning/training may be necessary.