Christmas is here. Have you been naughty? I sure hope so.

I looked over the kief tutorials, and frankly...was not impressed. While I'm sure the end result is good, It looks like work. Lots of work. Why not do this the easy way?

To build this you will need

a palm sander
a mirror
2 6 to 8 ft of 1by2 inch redwood slats (what you need depends of the size of your mirror)
1 4in wide board 2 inches wider than your mirror
4 1 inch blocks
and here's the important part;
a lenght of 80 micron screen. 4 inches bigger than your mirror.

You find these in any pool store. They are also used in Agricultural water filtertration....we found ours in the cane field.

Frame 4 squares the same size of your mirror....or better still make it a quarter inch smaller than your mirror and bevel a grove in so the mirror can slide in and out.
Put another square on top of that.
Take the last 2 squares and trap the mesh tightly between them.
Then put those two on the stack. Screw it all toghther.
Lay the board across the top on the blocks. Screw that down.
Palm sander on the board. Build a lip, so it stays there.

Below is a picture of the device. Also many gratuitious pictures of the end result. It took 5 minutes and almost 2 oz of crappy end of season weed to make what you see. We did not grind it, just shook the shit out of it.

Later we ground it down and shook it again, but that was far lower quality Kief. First shake is always he best.

It's also better to over dry, then freeze, what you are going to shake.

Give it a shot. You won't be disappointed.
oldhaole Reviewed by oldhaole on . Let's Make Kief...The EZ Way Christmas is here. Have you been naughty? I sure hope so. I looked over the kief tutorials, and frankly...was not impressed. While I'm sure the end result is good, It looks like work. Lots of work. Why not do this the easy way? To build this you will need a palm sander a mirror 2 6 to 8 ft of 1by2 inch redwood slats (what you need depends of the size of your mirror) 1 4in wide board 2 inches wider than your mirror Rating: 5