Results 1 to 5 of 5
-
11-14-2010, 04:09 AM #1OPJunior Member
Ph question
I just recently switched to hydro, ebb and flow and have a question about ph levels. If i have a barrel of feed and water with a ph of 6.5, can I just add "ph down" to bring the ph down to 5.5 or should I just drain the barrel and start over? I just wanted to make sure because i was told to adjust ph before adding feed.
Thank you
Joshw07Rolla Reviewed by w07Rolla on . Ph question I just recently switched to hydro, ebb and flow and have a question about ph levels. If i have a barrel of feed and water with a ph of 6.5, can I just add "ph down" to bring the ph down to 5.5 or should I just drain the barrel and start over? I just wanted to make sure because i was told to adjust ph before adding feed. Thank you Josh Rating: 5
-
11-14-2010, 07:15 AM #2Senior Member
Ph question
Just adjust the water with PH down, if then it is a bit too low, just add a bit of your 6.5 until you have it just right.'
keylime
-
11-14-2010, 01:13 PM #3Senior Member
Ph question
I have a 55gallon barrel in ebb and grow. When I change my juice I ph my water to 5.8 than I add my nutes .adjust ph about an hour later back to 5.8 using up or down depending where I am at. I am constantly trying to maintain a 5.8. As long as your between 5.5-6.5 should be ok.
-
11-14-2010, 01:20 PM #4Senior Member
-
11-14-2010, 10:59 PM #5OPJunior Member
Ph question
Originally Posted by keylime
Originally Posted by avon211
Advertisements
Similar Threads
-
Question about passing UA/ Question about vale
By mudnmascara in forum Drug TestingReplies: 7Last Post: 07-26-2013, 12:01 AM -
Question about Nutes and Water amounts (SPECIFIC QUESTION)
By dgskizzle in forum Growing InformationReplies: 2Last Post: 03-06-2013, 05:41 AM -
A follow up question to "the stupidest question ever asked"
By Epfin in forum Marijuana MethodsReplies: 15Last Post: 11-21-2007, 11:16 PM