Here is a previous thread where I, along with several other folks gave tips and techniques:
http://boards.cannabis.com/growing-i...procedure.html

Unfortunately we were not talking about a bubble cloner devise. I'm not necessarily saying you should abandon the bubble cloner because it's been widely successful for lots of folks. Most folks with bubble cloners also leave the stem hanging out the bottom of the plug, watch a bunch of YouTube vids to see what most have done successfully. While I can not advise too much on hydro, I have noticed most don't use a bubble cloner lid either. If you do use a lid be sure to leave it open a bit, perhaps twist it so the corners are open some. I'd put a temp/humidity meter in there to monitor temp/humidity. After the first few days open the lid to let them "air out and breathe" for a few minutes. They leaves should never remain wet and drippy for long. And less light, maybe two 13w CFL's sitting right on top or very close.

One more thing, great selection on the rapid rooter plugs. You should, however, take a little chunk and plug up the hole where the plant goes in to both; keep the air from getting in and drying it out, and it helps the cutting to stay solid and not wobble around and tear off the very first delicate roots. NOTE: This time I would not go back and plug the holes because disturbing them now could rip any roots that have started to form.

For now it looks like all is NOT lost. I'd trim the bad leaves after they are mostly no longer green or dead. I'd let them air at least once a day. If they don't wilt after 30 min try loosing the lid but watch closely. If they wilt again put it back for a few days more and try again.

Quote Originally Posted by Akumasensei85
Then how would you clone then, give me a technique to try and I shall.
That is a very fair question. I hate when folks say you're doing it wrong but also offer no help! I'm not that guy.

Good Luck and please keep us posted.
Doc Oc.
Ocotillo Reviewed by Ocotillo on . Clone problem Ok i started cloning like roughly a week and a half ago. My plants are not getting any roots, I'm using a buble cloner, with cloneX gel, Ph water and super thrive. I'm thinking should I just switch to water cloning instead? my Leaves are turning yellow and look kinda sickly. Rating: 5