Continued from last post...

Step Four:

Thread your wire through the cable fitting about 4 inches, and tighten both screws with a screwdriver.

Step Five:

Lay your lamp holder on top of the box and wrap the wire around each screw; tighten screws with screwdriver.

Step Six:

As an extra safety measure, cover screws with electrical tape.

Step Seven:

Mount lamp holder on top of box with supplied screws. Screw in a light bulb according to the wattage your lamp holder can support. Now Plug it in. You now have a portable light!
Probst Reviewed by Probst on . DIY Lighting I take no credit for this guide, I actually found it while I was searching for pumpkin stencils online. You can see the original here. I am no electrician, but I think I could handle a small project like this. I have thought about doing this to make my own fixtures that can support high wattage CFL lights, right now I'm stuck with those dinky cheap 'clamp lamps' from Wall-Mart®. Cannabis.com and myself DO NOT claim any responsibility to loss or damages from following this guide. If you Rating: 5