Will this cloning method work?!

[Macman9290]

Hey guys so i decided to clone my northern lights because they turned out female yay! Anyways i have always had terrible luck with cloning and i think its because i never gave them the humidity they needed and watching over them wasnt my forte. So this time around i didnt use powder i bought Clonex Rooting Gel and i put 4 clones into rockwool. I cut the plants at a 45 degree angle and made sure they were all about 3 inches long. (Ty Cannabis Grow Bible) After that i dipped them into the gel and slowly inserted them into rockwool then i placed them in this two gallon drinking container and sprayed them down with water then closed off the top with siran wrap. Now i played a blue light spectrum bulb over the top. This light gives a little heat off also. I will continue to open this once a day see how moist it is inside and give it a spray or two. Should this work any tips? Or ideas?


http://i214.photobucket.com/albums/c...992/clones.jpg

Macman9290 Reviewed by Macman9290 on 10-04-2010. Will this cloning method work?! Hey guys so i decided to clone my northern lights because they turned out female yay! Anyways i have always had terrible luck with cloning and i think its because i never gave them the humidity they needed and watching over them wasnt my forte. So this time around i didnt use powder i bought Clonex Rooting Gel and i put 4 clones into rockwool. I cut the plants at a 45 degree angle and made sure they were all about 3 inches long. (Ty Cannabis Grow Bible) After that i dipped them into the gel and Rating: 5

[keylime]

I think you have a wonderful chance of suffocating those clones unless you give them some air. I think the saran wrap is fine, but there should be some oxygen available for them. Just make sure it is NOT SEALED at the top. This will also give the humidity a chance of not getting too high, as 99% humidity will also not work. Humidity should be 70-80% no higher than 85%. Temp inside about 80F. Remove saran wrap completely after 2 or 3 days.

keylime

[Macman9290]

I'll poke some holes in the top for now. I have an air stone should I just pop that in there?