First off sarcasm isnt gonna get you no where. Not everyone reads the boards everyday so give us a dam break.

The system you are using has basically one very important step, the controller box and all buckets MUST be at same height. If box is on floor then buckets are too. If box is on a pallet the buckets are too. If they are at different heights then 2 things will happen, either you have a wet floor or buckets dont fill all the way.
2 ways to fix your problem, raise the buckets about an inch or 2 higher than the box or take some 1 1/2" or larger PVC tubing and cut about a 2" piece, place in bottom of bucket and then put liner on top of PVC. Thank you Daddynobucks for the PVC solution. Btw the answer was most likely in the setup directions that came with the unit.

Kindness pays off a hell of alot better than being an arse.