Step One: Get weed
Step Two: Get a 12 inch X 1.5inch PVC pipe with external threads on both ends
Step Three: Get PCV threaded caps
Step Four: Drill a shallow hole in one cap with 5/64 inch drill bit, then drill the rest of the way through the cap with a 1/32 inch drill bit. (these measurements will fit the 8 oz Gasone Butane)
Step Five: Drill many holes in the other cap, any small size is fine.
Step Six: Get butane (like for a butane torch, you don't need the torch part. My Fav is Gasone it comes in 8 oz, very cheap.)
Step Seven: Get filter paper (unbleached coffee filter paper should work fine)
Step Eight: Cut your weed up into tiny fragments (a coffee grinder should do it)
Step Nine: Place your filter inside the cap with many holes, make sure it overlaps the threads a little bit so it will be stable and create a good seal. Tighten the cap onto the PVC pipe (consider using plummers tape on the threads to prevent leakage)
Step Ten: fill your PVC with no more than 1 ounce of ground weed. Do not pack it in (at this point the filter paper and holey cap are at the bottom)
Step Eleven: Place the cap with single whole on top of pipe assembly. (again consider using plummers tape to prevent leakage)
Step Twelve: Get a glass tray or glass baking pan (you get it: something with a smooth glass bottom and sides to hold the liquid)
Step Thirteen: make sure you have plenty of ventilation
Step Fourteen: put out all sources of spark or fire (for safety reasons)
Step Fifteen: put the tip of the butane canister in to the single hole in the top cap. (if you cut the hole correctly this should work really well)
Step Sixteen: optional oven mitts.
Step Seventeen: With filter paper and holey cap over the glass baking tray, press the butane canister into the single hole to discharge the gas into the marijuana. Keep discharging until the can is empty or the pipe is too freakin cold to hold anymore. (Repeat once or twice to make sure you get it all)
Step Eighteen: wait for the butane to boil off
Step Nineteen: gather your marijuana honey oil from the glass using a razor blade or whatever
Step 420: enjoy (store in airtight, dark, cold place and get stoned for years)


benefits: butane has low boiling point so it will completely evaporate without residue. It will cleanly extract the potent chemicals in your weed and leave the crap behind. Butane is cheap the setup is cheap and the process is easy.

don't light a cigarette while doing this and blow up your apartment, you have been enlightened.


This is the future of marijuana. It condenses the raw form into a space saving, potency conserving, easy to store/transport, and it makes use of parts of the plant you wouldn't normally use.


note: crappy weed simply generates less honey oil. Awesome weed simply generates more oil. Once you have a repertoire of oils you can mix and match to create something entirely new. "lets see, i'll take a little ethereal high here and mix it with a little body high there and viola."
roddrumon Reviewed by roddrumon on . Honey Oil in 420 easy steps Step One: Get weed Step Two: Get a 12 inch X 1.5inch PVC pipe with external threads on both ends Step Three: Get PCV threaded caps Step Four: Drill a shallow hole in one cap with 5/64 inch drill bit, then drill the rest of the way through the cap with a 1/32 inch drill bit. (these measurements will fit the 8 oz Gasone Butane) Step Five: Drill many holes in the other cap, any small size is fine. Step Six: Get butane (like for a butane torch, you don't need the torch part. My Fav is Gasone Rating: 5