Results 1 to 10 of 16
Hybrid View
-
04-24-2005, 09:20 PM #1
Senior Member
water problem
For an RO setup you can use a bucket or large storage container. I use 2 55-gallon plastic drums and a float switch to turn off and on the water. You will burn through about a gallon for every 1/2 to 3/4 a gallon you make. Mine does 200 gallons a day and I don't run it full time. I only turn the water when I need to make more water. I do keep water in the system at all times.
I use flourex about 6" above for seedlings. You don't want the internal temperature of the leaves to get to hot. Don't worry about covering the rockwool until they pop out. You give them light when you plant the seeds.Zandor Reviewed by Zandor on . water problem hi, ive just recieved my gro tank 205 thru the post. the problem i got is the instructions say to soak the rockwool cubes over night in ph 5.5 - 5.8ph water. the supplied ph graph only shows up2 6!!! how am i meant to go lower. also, the measuring beaker supplied doesnt have any mls on the side and it doesnt say how much the beaker holds lol. i tried a little tap water to 2 drops of ragent or watever its called and it came out the worst (highest on the chart) which is 7.6. wud i be better using Rating: 5
Advertisements
Similar Threads
-
hard water...ppm/EC problem.....
By brickman45 in forum Indoor GrowingReplies: 3Last Post: 01-19-2012, 08:57 PM -
Hy Droton pH tap water mix problem
By jjm in forum HydroponicsReplies: 5Last Post: 12-21-2011, 11:45 AM -
Flushed with 6.4 PH Water - Run off in between 5.7-5.9...do I have Ph problem?
By razzapiggy in forum Plant ProblemsReplies: 6Last Post: 04-21-2009, 10:00 PM -
problem- i need to water plants without being there
By Nice Dreamz in forum Basic GrowingReplies: 9Last Post: 02-22-2007, 05:14 AM -
water problem
By mickireland in forum Indoor GrowingReplies: 16Last Post: 04-09-2006, 11:23 PM










Register To Reply
Staff Online