I've got tons of stuff lying around, so I decided to build a clonebox.

Equipment:

Hot Glue Gun
50w LED panel
(2) 80mm fans, 12V .15A each
12V 500mA AC-DC adapter
Cardboard

I used the totally useless-to-me UPS Express tubes I had spare. I used four of them, three to make the triangular box (The self-sealing helped with rapid construction,) and one to cut out and make the top of the box, which was hot-glued in place.

I cut out two 65x65mm ports, one about eight inches from the bottom and another on the same side about 15 inches from the top. One pulls in, one blows out.

I fixed the LED panel to the top of the box by knocking out three holes for the mounting bases to slip through, then used simple cuttings from a straightened wire coat hangar to keep it in place.

Plenty of room for about 18 or so large clones, temps stay steady at about 76-78 degrees, depending upon room temp in my office.

Took about 10 minutes to build, tops. Good to go for many years, now! I'll eventually reinforce the vertexes with a plastic skeleton, but for now, it's solid and doing the job!
khyberkitsune Reviewed by khyberkitsune on . DIY Clone Box - LED I've got tons of stuff lying around, so I decided to build a clonebox. Equipment: Hot Glue Gun 50w LED panel (2) 80mm fans, 12V .15A each 12V 500mA AC-DC adapter Cardboard Rating: 5