I found a method that gives me near 100% on my cuttings
LOWER limbs make better starts!All are 4"-6" tall prep by removing leaves and spurs,leave two top leaves and growing tip,but trim the ends off leaves if nessacery to the size of a pop can about 2" across.make the angled cut and quickly dip in 20:1 dip and grow solution. now this is what makes the differance, place the cuts 3-4 at a time in a small plastic cups with 1" of a solution of 10ml Thrive alive B1 red mixed in a gal of water. They soak in it 48hrs then get redipped in Clonex gel and set in rapid rooter plugs that have been split down one side so they can be opened like a book and the redipped starts layed in and closed up, then put back in the plug tray

The cups of water and the cutting tray are floated on a water bath in a tank that is a few inches of water in a 20gal GH nuit. tank with a heater at 70 degrees DO NOT COVER but they are sprayed with the same solution every day. down in the 20gal tank there is NO breeze to cause them to transpire extra water

I hope this is clear enough, I can answer specefics

Daddy
Daddynobucks Reviewed by Daddynobucks on . 100% clone rate I found a method that gives me near 100% on my cuttings LOWER limbs make better starts!All are 4"-6" tall prep by removing leaves and spurs,leave two top leaves and growing tip,but trim the ends off leaves if nessacery to the size of a pop can about 2" across.make the angled cut and quickly dip in 20:1 dip and grow solution. now this is what makes the differance, place the cuts 3-4 at a time in a small plastic cups with 1" of a solution of 10ml Thrive alive B1 red mixed in a gal of water. Rating: 5