Quote Originally Posted by Vancefish
All I can say is,.. Hope she improves, and sorry it happened. Not sure why the pest strip would have any effect though. I've done about double what you did and had no ill effects.

However I think you may like seeing this.

mums

Once you've seen, and read that. You'll see that your girl is far from doomed. Just give her care and don't try to over compensate.

Your clones should work well too.

I'm baffled.:wtf:

Me too! :wtf: I'm sure I did something wrong,... but that's a long f'n list of stuff to go over, so pin pointing it is the hard part,.... nothing that I had done on the list seemed to hurt her at all,.... till I put the strip in there, 7 hours later I had a 90% dead girl Probably a combination of all my little screw ups coming together at once.





It's a little after midnight, and I just got out of the room,... Mom is looking a bit better already, I'm seeing good growth (mainly branches) at all the nodes over 65 points of new growth since I almost killed her. I'm gonna loose a couple more leaves in the long run, but the remaining ones seem healthy enough to not fret over.

I got an active exhaust vent installed today, 6" computer fan in a 8" duct out the back basement window,... It's not much, but it's WAY more than I currently actually need (hard to get temps to climb with a single 96 watt T5 array!) And I got some seals on the door done up too,... it's not air tight, but helps, and will block light bleed to what will become my dedicated veg room. (4.5x6.5')


As I've already posted Mom is no longer in the little cabinet, but out in the main room under a goofy little 3 light(only 2 work ATM) strip that has 50w incandescent "Reflector" style bulbs in it,... it looks like it belongs in a bathroom right above the mirror, but it's got a plug, and the reflector lights are pretty focused (Hot tho!)so it'll work for now, I'm investing in more T5's soon.....


I got the main room humidity up to 50%, and with running the reflector lights as well as the overhead incandescent I've managed to get the main booth temps up to almost 78* and with the doors slightly cracked on the cabinet the temps in there stay around 82*


I'm trying to stay on the right track, even tho it got derailed, and it'll happen again,... suffice to say it's a learning experience!

I'm pretty sure I'm on the right track again, and I'm off to the races,.... but I just gotta ask the Pro's......

Any advice?