ez clone problems!!!!!

[cigarettes42]

cloner should be closer to 76f-78f.

that seems really warm water for a ez cloner. with my ez-clone recommended temps would be 68-72 degrees. when my ezclone water temp gt 75-78 i would get poor root growth comparing to other times when i could get the temp stable to 72.

about your powdery mold problem you should get it in check. get a bottle of serenade and spray em while in the cloner. just make sure you get a fan to dry em up after spraying. i had that problem and ive sprayed serenade while in the ez clone and worked great. you dont want that mold to feed on your leaves and spread.

[Jord0713]

not sure that water temp is that big of a problem....I can't keep my temp below 85 f. I cut my clones and drop them...No problems. I imagine I get between 95-100% success with my babies. I also use clonex.

[rick24wag]

keep water temp under 78 degrees, never shut off pump, i use humic tea, and g-rex from cutting edge solutions also keep air circulating on them. I also spray with a lite clonex feeding solution and hum tea. i just got done clonging 30 in my ez clone and 29 out of 30 were perfect. i found that cutting the end of the stem in half and scraping the side of the bottom of the stem worked best. got heavy roots in 7 days. good luck

[Gilbert]

Put new cuttings in ez-cloner yesterday. Checked on them this morning only to find that half of them were wilted and down for the count. I thought "wtf". Lifted the cover and the pump/manifold had leaned over to one side only watering one half of the cuttings. I fixed the problem and am now praying to rudy that they all make it. I hate it when 'dumb shit' stuff happens. aarrgghh

Yes, I am a new guy.

[Gilbert]

one more thing, for temp problems I change the water every few days minimum. Works fine for me. Gil