I needed a new vegging area for the clones. Common knowledge 'round these parts. So, I figure I might as well use what I already got.

I took the stand I was using before to bring the girls up to the light, and turned it into a tent. I had to remove the legs from the bottom, insert them into the top, and flip the stand over.


Next I took some panda film and wrapped it around 3 sides of the stand, securing it with duct tape.


..and finally I taped a flap to the front of the stand for easy access. Sorry for the over-exposed pic.


Here it is installed above the grow area, on the shelf in the closet.


Here is the stand with the flap lifted up. I taped the 8W T5 to the top of the stand, and put in the grow dome that the clones have been in.


Ta-Da! I have a vegging area separate from my grow area below. I still need to install some permantent ventilation, which will probably be a muffin fan, and make sure the whole setup is light proof.