Quote Originally Posted by ledtime
It's a DR100 39.5" x39.5"x72". Have a tower fan at full blast moving 90 degrees back and forth from the corner covering the entire area.
Are you using the screened intakes? A short length of duct, to draw directly @ floor level may help some. It's easy to make a flange with some cardboard and Velcro tape, to attach at the screened opening of a DR. (I've got an 80 & 120) If you've got a window nearby, it would allow you to draw from there. (assuming it's cooler out there,..wherever you are)
EvilCartman Reviewed by EvilCartman on . 400W HPS w/4" Sunleaves Windtunnel Fan Just a heads up to everyone. I've looked all over this forum and had to piece together info from several posts. My setup is the following: Carbon Scrubber (18" long x 6" Diameter - Closed cap on one end and 6" to 4" reducer on the the other) That is directly connected to the inlet of the 4" Sunleaves Windtunnel fan. I then have a 4" elbow to a 4" to 6" increaser. Then 6" aluminum flexible ducting to the bulb end of the cooltube. After that it's just 6" flexible ducting out of the Rating: 5