Activity Stream
227,828 MEMBERS
11293 ONLINE
greengrassforums On YouTube Subscribe to our Newsletter greengrassforums On Twitter greengrassforums On Facebook greengrassforums On Google+
banner1

Results 1 to 5 of 5
  1.     
    #1
    Senior Member

    Hanna Ph pen

    So i recalibrate my Ph pen using the 4.01 and 7.01 solutions. I did the 7 first then the 4, i also have the 10.01 solution but i use either the 4 or the 10, i used the 4 because well my ph is going to be right between 4 and 7 so i figured that would be the most accurate calibrating method. Once all is set and done, i wanted to test how well it was calibrated so i put it in the 10.01 solution and it reads out 9.73.... Is that bad? or is it just calibrated for the low ph? and not for the high ph? the Ph stays level and fluctuates about .01 sometimes/barely so i know the electrode is still good. A side note, the ph 10 solution packet busted open in the package, luckily it was the only one, and all the 3 were sealed together inside another bag. So i just poured it into a small jar i have, maybe the ph dropped? Either way i have the chemical test kit aswell and it reads yellow with slight tint of orange indicating a ph of about 5.8-5.9, the ph pen reads out 5.86 so i think its ok to use.
    JackdaWack Reviewed by JackdaWack on . Hanna Ph pen So i recalibrate my Ph pen using the 4.01 and 7.01 solutions. I did the 7 first then the 4, i also have the 10.01 solution but i use either the 4 or the 10, i used the 4 because well my ph is going to be right between 4 and 7 so i figured that would be the most accurate calibrating method. Once all is set and done, i wanted to test how well it was calibrated so i put it in the 10.01 solution and it reads out 9.73.... Is that bad? or is it just calibrated for the low ph? and not for the high ph? Rating: 5

  2.   Advertisements

  3.     
    #2
    Senior Member

    Hanna Ph pen

    if u have the hanna red pen it need's to be calibrated with 7.01 solution. i use gh brand 7.0 it ses error fault or something like that but it gives perfect readings.as far as the difference.its not much,and i wouldnt worry about it.

  4.     
    #3
    Senior Member

    Hanna Ph pen

    I'm using a two point calibration pen, specifically the Hi 99104.

  5.     
    #4
    Senior Member

    Hanna Ph pen

    You should be good to go on the 2 point calibration. My Hanna's PH probe only last alittle over a year with cleaning, calibration and daily use. They cost half what the pen cost to replace. If it checks with the 7.01 your good.

  6.     
    #5
    Senior Member

    Hanna Ph pen

    well for one it could of been contaminated when it busted open and 2 temp of the solution effects the ph read the pack it has all the suttle changes listed.

Similar Threads

  1. how to calibrate ppm on hanna hi98129
    By Felixthecat in forum Hydroponics
    Replies: 8
    Last Post: 10-24-2009, 02:24 AM
  2. HANNA INSTRUMENT
    By Felixthecat in forum Hydroponics
    Replies: 9
    Last Post: 10-05-2009, 02:18 AM
  3. Hanna PH/TDS meters
    By Dr.Hashman in forum Growing Information
    Replies: 5
    Last Post: 04-19-2007, 07:10 PM
  4. Hanna 4-1 tester the cheapest I seen
    By Weed4Life in forum Hydroponics
    Replies: 8
    Last Post: 02-17-2007, 08:06 AM
  5. picked up a new hanna unit
    By mellogold in forum Hydroponics
    Replies: 15
    Last Post: 08-28-2006, 12:15 AM
Amount:

Enter a message for the receiver:
BE SOCIAL
GreenGrassForums On Facebook