If the tape or the melts ya the fumes will get to u and be NASTY!!!!!!!!! but i think you should make somtin better...get any plastic bottle and a socket. Turn the plastic bottle so its not standing up, on its side. The burn a little hole(smaller than the circumfrance(sp?) of socket, this helps if its smaller so the pipe will be air tight), while it is still warm squeeze the socket in the hole. BOW you have one...thats what i did b4 i had a bong
OreO Reviewed by OreO on . Homemade pipe (health hazards?), read asap I rigged up a pipe using a pen shaft, I took its 'guts' (pen innards) out and then lightly heated the end piece were you would write from and bent it straight up. I then put a piece of metal tubing approx 1 inch long on the top so it squeezed down onto the pen until it could go no further. I used a small amount of white (non-toxic) school glue to seal the bottom. I then covered it with electrical tape. I put a bolt on the end and made an aluminum foil screen. I'll post pictures shortly. My Rating: 5