Results 1 to 10 of 57
			
		Hybrid View
- 
	10-25-2009, 04:12 AM #1 Senior Member Senior Member
 DWC setup helpi would drain as much out of the system as possible,just to be on the safe side. A general guideline for TDS levels : seedlings = 50-150 ppm; unrooted clones = 100-350 ppm; small plants = 400-800 ppm; large plants = 900-1800 ppm; last week of flowering = taper off to plain water. remember u need to subtract the ppm's of your tap water from your nutrients.if your bottle ses 600 and u have 200 to start with.your overal number is now 800 ppm and not the 600 most people think is there. disrupt86 Reviewed by disrupt86 on . DWC setup help Just went and purchased two 14 gallon containers to start a dwc. This will be my first time growing hydro. I have been reading threads of how many plants i should put in each container but everyone has a different numbers.. I am going to use a 600watt hps system. I was thinking of 3 plants in each container, so 6 in all. how many plants can I fit under a 600hps? I am going to setup it up tomrrow and will add some pictures. But any help would be great. Rating: 5
 
Advertisements
Similar Threads
- 
  New setup ok?By fred666777 in forum HydroponicsReplies: 29Last Post: 04-20-2009, 11:33 PM
- 
  possible setup?By headshake in forum HydroponicsReplies: 11Last Post: 11-22-2008, 08:25 AM
- 
  new setup. what do you think??By italian04 in forum HydroponicsReplies: 3Last Post: 06-10-2008, 01:39 AM
- 
  box setupBy atownsjuggalo in forum Closet / Cabinet GrowingReplies: 1Last Post: 05-04-2007, 12:18 AM
- 
  Grow Room Setup Posts :: Show Of Your Setup Here ::By blizma in forum Indoor GrowingReplies: 15Last Post: 08-14-2006, 01:58 AM











 
 
 
 
					
					
					
 Register To Reply
Register To Reply
 Staff Online
  Staff Online