Results 1 to 10 of 14
Threaded View
-
02-03-2010, 11:23 PM #14
Junior Member
Adding moisture to dry herb
I've had good success using a 1" square piece of paper towel and a few drops of water. Shake paper towel until it stops dripping, then simply stick it on the inside lip of your cure jar/container. One or two applications works wonders with no added funny taste (like lettuce!) In a perfect world, properly slow drying buds is a simple task. In the middle of winter in this Delta region (where I'm currently at) Tule fog and a wet week made it very challenging to slow dry and not worry about mold/mildew problems. I lost half of a grow to this problem once before. It's better to re-hydrate crispy pot than to throw mildewed pot in the trash.
Similar Threads
-
Cannabutter vs just adding the herb?
By ryuoch in forum EdiblesReplies: 4Last Post: 01-30-2011, 08:11 PM -
Adding moisture = mold?
By Mono in forum Marijuana MethodsReplies: 6Last Post: 12-07-2007, 09:54 PM -
some questions regarding moisture
By smokiesmoke in forum Marijuana MethodsReplies: 1Last Post: 12-11-2005, 02:02 PM -
Moisture of herb
By cameron123240 in forum Marijuana MethodsReplies: 3Last Post: 12-09-2005, 04:33 AM -
too much moisture a bad thing ? :D
By neilmcca in forum Indoor GrowingReplies: 2Last Post: 03-27-2004, 02:44 PM










Register To Reply
Staff Online