OK, followed StinkAttics guidelines and have confirmed the following:

1. The pH of the water I am using is in the range of 6.0.
2. After flushing Maureen, she is a daughter of Jane, is also 6.0. But I have to add that the flush was cloudy and did have sand particles in the run-off.

If I want to raise my pH how many drops/gal. do I add to the water?
Conversely, if I want to lower the pH, how many drops do I add per gallon of water?

Thank you again for you help, it is appreciated.
SWABLR Reviewed by SWABLR on . Yellow leaves Currently have three of my daughters in their third week of flowering and I have yellow leaves showing up. Also, have tested the pH of my soil and find it ranging from 7.0 - 8.0, very alkaline. I would like to get my pH back in range, 6.0 - 7.0, but do not know how to go about it? Any help you can provide is appreciated. Below is the Trouble Form I have filled out and I hope that I have provded enough information so that you will see what I have done wrong and what I need to do to correct Rating: 5