Activity Stream
227,828 MEMBERS
1668 ONLINE
greengrassforums On YouTube Subscribe to our Newsletter greengrassforums On Twitter greengrassforums On Facebook greengrassforums On Google+
banner1

Results 1 to 4 of 4
  1.     
    #1
    Member

    Need help fast with my clone

    I just transplant my clone into the soil and this is what it look like...my setup are as follows: foxfarm soil, 400watt MH hanging about 3-4 ft high. fan blowing..temp is about 78-82 degree humidity is 51 .. since i put it down i sprayed with growth excel twice and tab water...i need help to bring this back to life asap.......thanks
    shiloh Reviewed by shiloh on . Need help fast with my clone I just transplant my clone into the soil and this is what it look like...my setup are as follows: foxfarm soil, 400watt MH hanging about 3-4 ft high. fan blowing..temp is about 78-82 degree humidity is 51 .. since i put it down i sprayed with growth excel twice and tab water...i need help to bring this back to life asap.......thanks Rating: 5

  2.   Advertisements

  3.     
    #2
    Senior Member

    Need help fast with my clone

    are you using a humidity dome? what's tab water? what is the pH of your water?

    -shake

  4.     
    #3
    Senior Member

    Need help fast with my clone

    Is this picture the same day of transplant? If you used a bubble cloner or something, it may just be transplant shock/stress. I have had this happen to some clones, they were healthy as hell in the cloner, then once they hit soil, they went limp. By the end of the next day, they were perked back up and ready to go. Took about 3/4 days for em to fully recover and grow, but they did.

    The cure for mine was to harden them off sooner. I was leaving the dome on too long and I should have been exposing them to less humid air frequently to acclimate them to being outside the dome.

    Don't spray them anymore. It won't fix anything, it's only going to leave them moist and bring mold and rot possibilities with it.

  5.     
    #4
    Member

    Need help fast with my clone

    the clone was in the dome and was traveling in the car for one and half hour (hot weather) i took it home it was all looking nice and healthy so i transplant it into the foxfarm soil...the soil was warm because it was sitting outside in the sun for a day..i use the water from the sink not sure what the ph was but i assuming its around 8+ ..the picture show is a day after transplanting. half of my clone is dead now..still few left trying to survive..couple more looking pretty healthy i just put it in the pot under 1000w hps light..what can i do to save those weak plants? for the healthy one is it safe to put it under 1000w hps light...thanks

Similar Threads

  1. How many times can you clone a clone?
    By CrackLemonade in forum Indoor Growing
    Replies: 3
    Last Post: 09-12-2013, 01:25 AM
  2. Clone question...can you "stall" them? Or Re-clone?
    By Buzkill in forum Hydroponics
    Replies: 2
    Last Post: 10-25-2010, 03:52 PM
  3. Clone's dying, fast (Picture Included)
    By liquidtrust in forum Plant Problems
    Replies: 2
    Last Post: 08-25-2008, 03:29 PM
  4. reveg & clone a clone
    By evertking in forum Basic Growing
    Replies: 1
    Last Post: 03-08-2007, 09:35 PM
  5. How many lumens needed to clone with one clone dome?
    By J DOG 6000 in forum Indoor Growing
    Replies: 3
    Last Post: 02-25-2006, 10:38 PM
Amount:

Enter a message for the receiver:
BE SOCIAL
GreenGrassForums On Facebook