Results 21 to 21 of 21
Threaded View
-
08-16-2009, 09:16 PM #1OPMember
Brown tips and edges, pictures and data sheet
I have brown tips and edges burning but my stats are at what the makes of my food say... So I am not sure it is not a full blown wide spread problem just here and there it pops up and I don't want it to become a full blown problem.
Problem Sheet
First Hydro Grow
Your Equipment:
.1) Type and wattage of lights. (MH, HPS, CFL's, tube fluorescents, LED's) 300w HPS 1ft from tops, 300w CFL just above the plants
.2) Distance from tops?
.3) Reflector type? (cool tube set-up, bat wing, enclosed reflector, bare bulb...) CFLs Bare, HPS enclosed reflector
.4) Is there a consistent fresh air supply? yes
.5) Do you have an exhaust fan and a circulation fan? yes
.6) What are the bulb wattages, kelvin ratings, and schedule?24/7 HPS Guessing about 2400, and CLF 5500
Your medium:
.7) Specific brand and type of soil, (coco, peat based soilless...) and anything you've added to it. (vermiculite, perlite, worm castings...)Some are in coco sitting in the clay balls, and a few are in this white poly stuff â??seeing how the poly works it is cool had some aglea problems but is cool stuff.
.9) Did you use peat pucks (or similar) to root clones or germinate seedlings? Some seeds some clones
Your nutrients and water:
10) Source of water? (tap, bottled or filtered) What's it's ph before adjusting? Tap Water Ph befor 7-8
11) Method of checking water ph. (ph pen, test strips, aquarium test kit...)aquarium test kit
12) Method of adjusting water ph. (phosphoric acid, white vinegar, hydrated lime, PH Up...)Ph up, And Ph Down
13) Specific brand and N-P-K ratio for each bottle. List dosages (quantity per gallon) and current feeding schedule. Sensi Grow A&B it is a two part mix you add them Part A is 3.7-0-0 Part b is 2.5-2.2-5.7 Running at 600 ppm as recomended
14) How often are you watering between feedings, and how much per watering? hydro drip system some of my roots have made it to my tank so some of the roots are always wet but I am pushing lots of o2 into the water
15) Any additives or tea's? (Superthrive, CalMag, molasses, Mother's Earth...) No but thinking of adding molasses?
16) Are your ph levels stable, or do they fluctuate?No my run off drops pumps up my adjusted Ph from 6.0 To 7-8
17) What is your ingoing water's ph?6.0 ...your runoff ph? 7-8
18) Do you foliar feed? If so, with what, how often, and at what time do you spray? not any more
Your growroom:
19) Indoors or outdoors? indoor hydro
20) What size of closet, room or hut?6x3x8
21) What are the temps and humidity levels while lights are on? temp about a constant 78 humidity not high ...With lights off?
22) Have you seen signs of insects in the growroom? Clean as a lab
Your strain:
23) What strain are you growing? (Indica dominate or Sativa dom?) some o.g. Kush and some carmel kush so both
24) From seeds or clones? some clones some seeds
25) Is this an autoflower strain? nomendelsdream Reviewed by mendelsdream on . Brown tips and edges, pictures and data sheet I have brown tips and edges burning but my stats are at what the makes of my food say... So I am not sure it is not a full blown wide spread problem just here and there it pops up and I don't want it to become a full blown problem. Problem Sheet First Hydro Grow Your Equipment: .1) Type and wattage of lights. (MH, HPS, CFL's, tube fluorescents, LED's) 300w HPS 1ft from tops, 300w CFL just above the plants .2) Distance from tops? Rating: 5
Advertisements
Similar Threads
-
Need a little help from my friends - Data Sheet Included!
By dodo5678 in forum Plant ProblemsReplies: 3Last Post: 11-15-2009, 08:09 PM -
Brown edges and curling
By ic3blink in forum Plant ProblemsReplies: 1Last Post: 07-27-2009, 10:30 PM -
Will heat cause brown edges?
By chadsvb in forum Indoor LightingReplies: 7Last Post: 04-22-2007, 07:17 AM -
Yellow tips turn to brown. I'm back with pictures.
By Opie Yutts in forum Plant ProblemsReplies: 9Last Post: 02-18-2007, 11:39 PM -
Brown leaf edges.. What's the problem?
By Exclamation221 in forum Plant ProblemsReplies: 4Last Post: 01-22-2007, 11:29 AM