Go to the hardware store and look for something that would work as a bowl, then get some silicone sealant and something to use as a stem (preferably a 4-6" stainless steel pipe/tube no more than 1" in diameter) then find a good chamber (If you can just use a gallon jug, Arizona Tea gallon jugs work super because they're so thick but still flexable) then have the hardware guys cut some flexable tubing for ya (make sure it doesnt reek too much like plastic cause then it makes the smoke taste like plastic) then just cut holes with an exacto knife (make em smaller than they need to be so that when you shove the stem and hose in it makes an airtight seal, cause if you dont then you have to use the silacone sealer and that sucks) well anyways when you have the holes cut (1 for stem/bowl, 1 for hose, optional 1 for carb) then just attack the bowl to the stem with the silacone sealer and pop it in then stick the hose in (i put the hose into the lid and the stem into the place right next to the base of the handle) then fill with water to that it covers the base of the stem about 1-3" but not so high that it goes bast the hole you cut then make it so that the hose is well above the water line and then pack that bowl full and rip that shit til you pass out!!!!
daZenfmeister Reviewed by daZenfmeister on . going to hardware store later hey as the title says im going to the hardware store later to find pecies to make a pipe. what kind of material should i look for and use. if have made one by doing the fulling please tell me what all u did use and what the pecies are called thanks Rating: 5