SWIM has been recently experimenting with extraction methods, use in e-cigs, and legitimate store-bought vapes. SWIM rigged drilled a hole down the middle of an approx. ~5/8" long bolt in a diameter suitable for the butane canister to seal against it and spray (Important- make sure the bolt's threads are just slightly larger than the ID of your tube)a. Then, 3/8" ID stainless tube was cut down (in order for a small "test batch") and one end was drilled/tapped to accept the bolt. At that point, a coffee filter followed by a square of window screening was attached to the open end (after it was packed with the material to be extracted) and those filters were attached with a hose clamp. Used very little material but had a successful extraction. Going to pass on the freezer ideas for condensation and freezing the base material, SWIM might give that a try in a few. . .
wylekyote Reviewed by wylekyote on . Did a small scale BHO extraction yesterday... It went well :thumbsup: At first I threw a bowl in a pyrex container and was thinking only a few drips would come out... WRONG! Next thing I know I'm pressing the butane to my device and out the bottom comes pouring butane... My bowl gets completely soaked, in butane.. Looks frozen, infact it is.. I'm like oohh no what have I done with my buds??? The bowl that was in there turned into a sticky super crystally looking bowl and below that theres slug looking trails of sticky goo. Yep, it Rating: 5