Quote Originally Posted by cigarettes42
wow those look bad. you shoulda kept the water clean with out nutes. i got an ez clone too and dont use nutes in it at all, i just use a little bit of root hormone(mostly used to prevent air bubbles cause you really dont need hormones for bubble cloners). when i place the cutting in it, the cuttings will perk up in like 3 hours and stand up like normal plants. here was my check list. tell me if you followed it. it also maybe the intensity of your light.

1. leach out the mother plant with h2O a week prior to taking cuttings off.
2. the day of cutting your mother give it another watering.
3. prep all your tools
4. make a cut 3-4 nodes down, place cutting directly in some water or root hormone to prevent air bubbles in the main stem.
5. trim the fan leaves
6. make sure the cloner temp dont get past 78! mine got hot so i just placed a little fan on it and it cooled it down

if there is something i missed guys add it in please!
the clones were already cut when i got em so im not sure how he did it. the guy does have a lot of experience, so i dont think the problem was before i got em.

the light guy suggested 12-36'', i started out at 36'' and been lowering little by little tryin to find the sweet spot but im down to 14'' and they havnt responded to the light height at all. they just slowly lose leaves from the bottom up. the main stem stands up but all the fan leaves stay droopy.

what about co2 levels? i run a sealed room and i currently have it set at 350 but when i work in there it can easily raise well above 1500.