wow those look bad. you shoulda kept the water clean with out nutes. i got an ez clone too and dont use nutes in it at all, i just use a little bit of root hormone(mostly used to prevent air bubbles cause you really dont need hormones for bubble cloners). when i place the cutting in it, the cuttings will perk up in like 3 hours and stand up like normal plants. here was my check list. tell me if you followed it. it also maybe the intensity of your light.

1. leach out the mother plant with h2O a week prior to taking cuttings off.
2. the day of cutting your mother give it another watering.
3. prep all your tools
4. make a cut 3-4 nodes down, place cutting directly in some water or root hormone to prevent air bubbles in the main stem.
5. trim the fan leaves
6. make sure the cloner temp dont get past 78! mine got hot so i just placed a little fan on it and it cooled it down

if there is something i missed guys add it in please!
cigarettes42 Reviewed by cigarettes42 on . clone issues, tell me what you guys think. hey guys, this is my first stab at cloning, im on day 8 now and things arent lookin too good...not terrible yet though. im using an ez cloner, ph never goes outside of 5.8-6.3 range. water temp stays between 75-80º. air temp is set at 70, humidity is usually around 90% and nothin fluctuates much at all, im able to keep all that stuff pretty consistant. roots started showing on day 2, and only a few of them are showing really good root growth, thre rest just have some roots here and Rating: 5