I had intended to keep a detailed account of this first go-round, however between my hard drive crashing and the boards being down, I'm afraid this log is going to be a little less then complete.

Cab Dimensions
33.5" deep x 22 3/4 wide x 46 3/4 tall


Lighting
(12) 23w 5600k CFL's (Veg)

(4) 42w 2700k CFL's (Flower)
(8) 23-26w 2700k CFL's (Flower)

Ventilation
120mm Computer Fan
3-Speed Oscillating fan

Temp
Living in a southern state has presented a few problems, temp wise. 20-30 degree swings and an unseasonably warm winter have provided their share of difficulties. Now that winter has finally settled in, temps tend to stay between the high 70's and low 80's.
Temp readings are taken by one of these:Aj MOSS | Mini Temp Ir Thermometer by Raytek that I had laying around.


A few improvements have been added since these pictures were taken. The passive intake was expanded to 8"x4" while the fan was relocated inside the cab. I've ghetto rigged a light trap for the exhaust out of a shoebox, but I'm probably going to be forced to rethink the whole exhaust setup. Either by adding a second computer fan and finding a better designed light trap or give in to this newfound hobby and invest in a quality can fan.

The smaller part of the cab is not yet in use. It will either be used for clones or a mother somewhere down the line, hopefully after I recieve a rooted clone of either Sensi-Star or Bubblegum.

Now on to part II - The Plants!
RamblerGambler Reviewed by RamblerGambler on . 1st Go-Round - CFL's and Bagseed I had intended to keep a detailed account of this first go-round, however between my hard drive crashing and the boards being down, I'm afraid this log is going to be a little less then complete. Cab Dimensions 33.5" deep x 22 3/4 wide x 46 3/4 tall Lighting (12) 23w 5600k CFL's (Veg) (4) 42w 2700k CFL's (Flower) Rating: 5