slimey root

[marleyhb]

SCL-Anything you have added to the soil
SCLR-Soil or slab runoff pH
E-Water source
E-Source water pH
HRT-Source water EC (if hydro)
E-Age of plant
E-Type of fertilizer
E-Rate of application (if hydro, this is your PPM number, preferably after each component is added)
E-Lighting source and distance from plant
E-Air temperature (both day and night if you are running a dark period)
HD-Reservoir temperature
E-Air % Relative humidity
E-Lighting schedule
E-Type of ventilation your room has
TR-Did you pre-soak your media in pH corrected solution?

ok so here is my list:

they do look a little better this morning however

growing hydro in an aeroponics bubble bucket.
obviously indoors.
getting fresh spring water from the water store down the street.
planted from clones. been in the bucket now for ten days.
dont know my ppm. (just ordered a ppm meter.)
light is a 400w HPS. distance is now 16 inches from tallest lady. was closer though for a few days. 18-6 light/dark
ph of water is between 5.8 and 6.2
day temp. 78-82 night temp 72-78
between 30 to 40 percent humidity
4 inch venting in and out of light. 4 inch fans sucking in fresh air and also one blowing out warm air.
not sure of res temp. will check that tonight though

[marleyhb]

also i am using GH nutes. just the regular M, B, and G

[stinkyattic]

With the range that your room goes through, your res temp is probably just fine.
The only thing I see in your system that is a big unknown is the water. Spring water? Is it for drinking? When you get your ppm meter, stick it in there. Also do you ahve other water options? A lot of water meant for drinking has a lot of sodium in it that you don't want, so in some cases even tap water is safer.
The low dose peroxide treatment recommended above should help clear up the slime, and always make sure you have LOTS of bubbles in the bucket! Root rot loves low oxygen conditions. And if you run a beneficial bacteria in your res to prevent future slime issues, that is good too. But it is one or the other because the peroxide kills bennies too.

[marleyhb]

thanks a lot stinky. Im starting to like you. the water is meant for drinking yes i think. so when i get that ppm meter i will check it out.

[marleyhb]

hey the upward growth has stopped almost completely on my ladies. will it ever return? the roots are rebuilding and the plants look decent again, just not moving up...

[marleyhb]

my ppm is at 640. sounds pretty good for clones that have been in the bucket for only 11 days ya?