Results 11 to 20 of 20
-
11-27-2008, 09:30 PM #11
OPSenior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
Bueller?
-
11-27-2008, 10:56 PM #12
Senior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
I don't grow nearly that much, so I do the bathroom tub thing. If you do 20 or 30 per week, it would split the burden and likely help lower the ambient humidity versus doing them all at once. No doubt about it tho...it quickly becomes a buzz-kill of a chore.
Originally Posted by razzapiggy
Regarding the pump...I'd make sure to have an overflow prevention/management strategy, as Murphy's Law dictates you will soak everything at least once.
Auto drip sounds good, but don't the plants directly under the lights need more than those twords the outside?
I personally can't justify the expense for salt leechers or flush solutions. Takes a few days, but pre-harvest flushing works well for me, and I can spend the extra cash on stuff like......bills. :thumbsup:
-
11-27-2008, 11:36 PM #13
Senior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
3ft3"by3ft3"
Originally Posted by razzapiggy
-
11-28-2008, 02:03 AM #14
OPSenior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
Thanks for the suggestion but having several phases of plant growth to break up the work would likely create more problems than it solves for me. That may not be true for everyone else.
Originally Posted by Rusty Trichome
As the plants on the outside needing more water than the ones on the inside, sure... but I don't think any significant portion of extra water will be needed. If I need some extra water to one or two isolated situations, I can always just throw another dripper in that plant though I don't see that being the case.
I think I've decided to grow the plants on the ground almost for certain on this next cycle. This requires me taking down all the tables I built and figuring out the logicistics of watering 60 plants with a drip system working against gravity to get the water both out of the resi and then returning the waste water TO the resi.
-
11-28-2008, 02:05 AM #15
OPSenior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
Haze thanks for the reply. My clone supply is far too small for something like that as of right now, but I will consider a SOG method in the future. As for now, I am going back to basics and replicating what I did the very first time I grew pot, only this time I will be setting up an irrigation system instead of doing it by hand (huge pain in the ass!) I got a pound per 4X4 area my very first time growing grass, so I figure the new technology should help that number out a bit!
-
11-28-2008, 02:06 AM #16
OPSenior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
Will the pump seen at Amazon.com: Flotec FP0S1300X-03 Tempest 1/6 HP 1,500 GPH Utility Submersible Pump: Home Improvement work to power my drip system with the water being held in a garbage can? Thing can pump 1500GPH so I would assume so
-
11-28-2008, 07:33 AM #17
OPSenior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
Your Approach sounds great in a vertically challenged room as well, however I need a hefty clone stock ready to rock... then I'll try that way too.
Originally Posted by xxxhazexxx
-
11-28-2008, 08:00 AM #18
OPSenior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
Just measured my plants just cut and most of them were 19-22 inches tall when they were dropped. Jeez, I vegged the things for like two weeks - wonder why so small.
I'm trying to figure out if I should just do one more cycle with the tables the way they are and try to get the extra height available *with the tables where they corrently* because heck I mean I should be able to grow them about
Err, I always love harvest times, but it sure gets me thinking about what adjustments I should make in the next week or so.
It's troubling for me, because still, two years after I got into this thing... my very first run through was the best, most simple, I had the least logic, and even still... I have not been able to touch it. Pissing me off!
-
11-28-2008, 11:12 AM #19
Senior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
goodluck m8 when your up and running post some pics:thumbsup:and check out my cheese grow in indoor growing :jointsmile:
-
11-28-2008, 08:37 PM #20
OPSenior Member
Dealing With Height Restraints in 3600 Watt Grow - Advice Appreciated
I simply can't decide weather or not to cut the tables down or not... last time I only grew them to 19 inches, I could do another 10 or so inches even with the tables still in place.
How much growing space do you guys have *after* tables and lights and space between lights are accounted for?
Advertisements
Similar Threads
-
1st indoor 400 watt hps grow. (help or advice appreciated)
By 1817 in forum Basic GrowingReplies: 1Last Post: 07-03-2013, 10:17 AM -
3600 watt HPS Set-up Question??
By SDboltz619 in forum Indoor GrowingReplies: 2Last Post: 01-20-2011, 07:59 AM -
1st grow advice is appreciated...
By superskunk1 in forum Indoor GrowingReplies: 25Last Post: 12-31-2009, 12:49 AM -
1st grow! advice appreciated
By curious101 in forum Indoor GrowingReplies: 10Last Post: 05-22-2007, 11:55 PM -
600 Watt HPS setup issues... Any advice appreciated!
By Smokey Robinson in forum Indoor GrowingReplies: 8Last Post: 10-19-2006, 12:31 AM








Register To Reply
Staff Online