Ok well 14g of one substance CAN fit in 14g of another substance (all depends on DENSITY). ie, 14g of cadminium could fit in 14 g of hydrogen... however obviously 14g of weed would not fit in 14 g of oil.. however 14g of thc COULD fit in 14g of oil however if it does or not Im not sure and dont feel like figuring it out.

Now on to saturation... I am sure you are aware that saturation is a function of temperature and the molecules you are using. Basically with majority of solutions the more you increase the temperature the more you solute(thc in yoru case) you can get in the solution(oil). However, there is a point where if you put the nugs in the oil its going to cook them and cook the thc so this would be the limiting factor to get the maximum THC in the solution. So whatever the temperature.

So what i will explain to you is (hypothetically, Ive never actually done this but from a chemistry standpoint this is what makes sense) how to MAXIMIZE the thc content. Heat the oil to a temperature below the thc boiling point to maximize the aborbtion of THC. (I quickly searched and found its about 200 deg C but this may be incorrect see what temp vaporizers run at and this is the temperature you would want the of the oil to be minus 10 degrees to be safe so say 190). If you are wanting to use a small amount of oil to absorb the max amount you will have to put a small nug into the oil let it stay in there for some time say 5 minutes, then remove it with tongs or something, then put another piece in so that they are submerged. Keep repeating this until you have the amount of weed you want in it. Im assuming that any consumable ammount you would like would absorb into the oil this way, however im not a chemistry graduate or anything just have some engry level university chem. However this would be a good way to get more in than you could if you were to do this at room temp.