Advice on a growspace

[Lit Up]

Either or would probably be sufficient. Y splitters are God's gift to man, I suggest using them to double you lighting without taking up a lot of extra room.

[RamblerGambler]

Back from a busy night shopping around the hardware stores and I've got about 90% of my materials. I'll put the primer on tonight and assemble the cab sometime this weekend.

Unfortunately on the inline duct booster fan front, I was left hanging by both Lowes and HD. Apparently they do not carry them in the store and they are unable to order from the catalog. Talk about pure logic, you list an item online but are somehow unable to acquire it at a physical location. So now I must either buy it offline or try some other hardware stores.

Lit Up- I'm going to pick up 2 Y splitters for side lighting tomorrow. I figure that I can put two 6500k bulbs in for vegging then switch over to 2700k during flower. Should be workable, right?

[Lit Up]

Very workable.

[RamblerGambler]

Construction begins at last! At this point the 4th coat of flat white paint is drying, so we'll see what it looks like in the morning. Sorry for the quality of the pictures, I'm using my phone until I can dig my camera out.

[GoldenGraham84]

looking good bro. keep on keeping on. :thumbsup:

[RamblerGambler]

And away we go! The first step of assembly has brought about its share of problems. Do do a slight oversight during construction, I've somehow managed to screw up the dimensions. This has created a conundrum. I can either reassemble and retry, or simply go with the current setup. Currently the cab 33.5" deep x 22 3/4 wide x 46 3/4 tall.

I'm thinking I might just pull the desk out completely and push the cab all the way to the left (see pic in 1st post). I'd still need to partition it for separate veg and flower chambers though. Should I take this course of action?

[RamblerGambler]

After spending way too much time repairing my early attempts at carpentry, it looks like I'm finally back on track. I'll start wiring it up sometime during the next couple of days, putting 4 fixtures on top plus finalizing plans for side lighting. I don't have much electrical experience, but wiring 4 fixtures in parallel doesn't seem like it should be that hard. (Advice welcome)

Hopefully construction will be finished by next week, and I can finally get the show on the road.


Pic 1 - Cab on it's side
Pic 2 & 3 - More unfinished cab

[RamblerGambler]

Thoughts on lighting - I'm thinking of taking the easy way out and going with a setup similar to the one pictured, only with another 4 light fixture on the opposite side. CFL wise, I originally thought about going (4) 40w and (8) 23w
w/ Ysplitters, but I'm starting to run low on cash. Could I get by using more 23w to compensate?

(2) 4-light wall bracket Progress Lighting Broadway Collection White 4-Light Wall Bracket - P3298-30 at The Home Depot (Like this but cheaper)


Side lighting is still a concern, but i'm thinking maybe just throw in a $5 3-light fixture from WallyWorld. Thoughts? Opinions?