Thanks Killa...I ended up taking a different route.

I ended up with this schedule:

Sunday 10/19 -----> started high P low N diet to build carbs to help in root growth...Text

Thursday 10/23 ----->took 3 clones from each plant (total of 66 clones...tough on your back)

Saturday 10/25 ------>res change...added Bushmaster (new additive that supposably slows stretching when going into flowering), progrow flowering, calmag, LK, subculture (promote healthy bacteria on roots)

Taking clones:
1) I cut the clone
2) scar it and cut off fan leaves
3) immediately then dip in ROOTECH
4) trim leaves while in RT
5) jab scissors into bottom or sunleaves version of rapid rooter and insert clone
6) mist dome and place on dish
7) 24hr light (34W t5)

****After doing all the bending I could I have hit my height restriction for veg so I MUST flower this sunday (3 days after clones were taken)...I know this is bad due to stress but no room. ANY SUGGESTIONS??? My idea was that YES this will cause additional stress but as soon as I can sex them I can cut down the males and tie down any sites that are TOO HIGH.******

THIS IS ALL QUITE AN EXPERIENCE-AND NERVE RACKING AT TIMES TOO. I have checked them everyday but have come into low res's and other stupid little problems too. Takes effort but such a sense of satisfaction...
el chupanebre Reviewed by el chupanebre on . First Grow: WW, BG, Haze/Skunk El Chupanebre's Setup E-indoor or outdoor E-soil, soilless, coco, aero, or hydroponic E-specific medium rapid rooter surrounded by hydroton CSL-Soil type/brand HCL-Hydro/aero/soilless system type NFT constant stream SCL-Anything you have added to the soil SCLR-Soil or slab runoff pH Rating: 5